300 yards is equal to how many miles?
Response:

• A.0.41
• B.0.28
• C.0.17
• D.0.39

Comment: *

Name: *

Email: *

Verification: *

A review of a first piece inspection report for an 8 cavity plastic bottle mold indicates that bottles from six of the eight cavities had a finish diameter of exactly 0.415 inches. The upper specification limit for this dimension is 0.415 inches. The first piece inspection was accepted.
Which of the following types of inspector error best fits this example?
Response:

• A.Rounding off
• B.Distraction
• C.Bias
• D.Flinching

Comment: *

Name: *

Email: *

Verification: *

Of the following, which is used to accelerate the forming phase of team development?
Response:

• A.Documenting and reviewing the team's goal
• B.Defining technical process
• C.Defining action items, responsibilities, and timing
• D.Team-building exercise

Comment: *

Name: *

Email: *

Verification: *

You are performing a Gage R&R study using electronic micrometers. The display is X.XXXX and the last digit is either a zero or a five. You read the manual that comes with the gage and it indicates that it is accurate to .00002".
Assuming that the tool is sufficiently accurate, how should you perform your study?
Response:

• A.Do not use the gage for any measurement that requires a resolution of more than .0002"
• B.Enter a high and low reading for each measurement based on the .00002" accuracy
• C.Dismiss the last digit as meaningless and do not record it for the study or include it in your calculations
• D.Include the entire value displayed for the measurement in your calculations, but be aware of the rounding off in your decisions and analysis

Comment: *

Name: *

Email: *

Verification: *

Which of the following shapes of the indenter tip of a hardness tester for metal is associated with the Rockwell test method?
Response:

• A.Diamond pyramid
• B.Pin indenter
• C.5mm ball
• D.Conical diamond

Comment: *

Name: *

Email: *

Verification: *