Arrange the following failure data steps into the correct sequence from start to finish.
I. Verify the failure.
II. Identify and control the failure.
III. Investigate the failure.
IV. Provide corrective action and follow up.
V. Report the fail.
Response:

• A.III, II, V, I, IV
• B.I, II, III, IV, V
• C.II, V, I, III, IV
• D.I, II, V, III, IV

Comment: *

Name: *

Email: *

Verification: *

A systematic approach to analyze fault trees requires all of the following EXCEPT Response:

• A.Tolerance stack-up analysis
• B.Hierarchical diagram construction.
• C.System definition.
• D.Quantitative evaluation.

Comment: *

Name: *

Email: *

Verification: *

The equation below represents

Response:

• A.The limits for a Range chart.
• B.The limits for an X Bar control chart.
• C.The probability of meeting specification.
• D.The process capability adjusted for centering.

Comment: *

Name: *

Email: *

Verification: *

A qualification test is used to determine that design and selected production methods will yield a product that conforms to specification.
An acceptance test is used to determine that a completed product conforms to design. On this basis, a destructive test can be used for:
Response:

• A.Neither qualification nor acceptance.
• B.Qualification or acceptance.
• C.Acceptance only.
• D.Qualification only.

Comment: *

Name: *

Email: *

Verification: *

Given mean-time-to-failure of 200 hours for each of two components, what is the probability of system failure if both components operate in parallel for one hour?
Response:

• A.P = 0.001
• B.P = 0.010
• C.P = 0.000025
• D.P = 0.005

Comment: *

Name: *

Email: *

Verification: *