Free Avaya 6101-1 Exam Dumps Questions & Answers

Which statement describes how to configure Simple Loop Prevention protocol (SLPP) Rx?

• A.SLPP is configured on the uplink ports of both the core switch cluster and the edge switch
• B.SLPP is configured on the Inter Switch Trunk (1ST) ports of the core switch cluster.
• C.SLPP is configured on the core switch cluster ports that connect to the edge switch.
• D.SLPP is configured on the edge switch ports that connect to the core switch cluster.

When configuring an Ethernet Routing Switch (ERS) 8600 for Split Multi link Trunking (SMLT). Protection against an edge switch in the factory default condition must be taken into consideration.
Which parameter WILL help prevent loops on the SMLT ports?

• A.LACP Enable
• B.Discard Looped Frames
• C.Spanning Tree Enable
• D.Discard Untagged Frames

Based on the command line output shown in the exhibit, How many Gigabit Ethernet ports are available on this Ethernet Routing SwitchlT (ERS) 8600?

• A.26
• B.24
• C.16
• D.28

Set of procedures will upgrade the boot monitor on an Ethernet Routing switch (ERS) 8600 with a single 8692SF module?

• A.Copy the new Image to flash Boot the new image
• B.Boot the new image
• C.Copy the new image to flash Modify the boot choice for rim-time image Boot the new image
• D.Modify the boot choice for run-time image
• E.Copy the new image to flash Activate new image with SF module in service

When configuring Ethernet Routing Switch (ERS) 8600 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI.
How is the ACLI interface obtained?

• A.Use the abort command and enter "no" at the default interface prompt
• B.exits the CLI and chooses ACLI at the interface manager prompt.
• C.Change the ACLI boot flag and save the boot configuration file.
• D.Change the interface type in the config.cfg file.