Free Avaya 6103 Exam Dumps Questions & Answers

Refer to the exhibit.

A technician has just enabled SLPP on both core switches, and is reviewing the network diagram and console output from the core 1 Ethernet Routing Switch (ERS) 8000.
Given the output shown in the exhibit, what is the configuration error on the edge switch?

• A.The edge switch spanning-tree has not been configured.
• B.The edge MLT has not been configured.
• C.The edge VLANs have not been configured.
• D.The edge switch access port rate limiting has not been configured.

QoS is the ability to manage the performance of data flows by giving treatment to the data flows, users, and applications.
For which two network problems would QoS be a good solution? (Choose two.)

• A.slow route table convergence
• B.end-to-end delay
• C.interface duplex mismatch
• D.network loops
• E.lack of bandwidth

An engineer is configuring the VSP 9000 for EDM management, and cannot connect from the EDM computer to the VSP 9000.
Once logged into the ACLI, which show command is used to see the status of the web server?

• A.show sys webserver
• B.show web-server
• C.show ip web-server
• D.show vsp edm server

What information do these messages determine?

• A.Speed and Link type
• B.Speed and Duplex
• C.Speed and link status
• D.Speed and Protocol

During a power-on or cold-start sequence, at which stage can the flags to change the operational environment of the switch be set?

• A.the image search
• B.the boot monitor prompt
• C.the boot configuration prompt
• D.the system test