Free CWNP CWDP-302 Exam Dumps Questions & Answers

When deploying long-distance 802.11 bridge links (10 miles / 16 km), what parameter may be critical for improving data flow by reducing retries caused by the long distances?

• A.The acknowledgement timeout threshold
• B.The sequence control field value
• C.The CTS-to-self threshold
• D.The minimum transmit data rate value

In a PC-based spectrum analyzer, what data chart identifies the overall RF utilization of a specific frequency in the environment being surveyed?

• A.Swept Spectrogram
• B.FFT Average
• C.FFT Max Hold
• D.Duty cycle

You have enabled a feature in a controller-based environment that results in data arriving at the destination more quickly when sent through the APs. It also limits some other features of the solutions.
What feature has been enabled?

• A.Centralized forwarding
• B.Distributed forwarding
• C.Frame fragmentation
• D.SSID hiding

You deployed an AP and installed its antenna, and you now need to set the AP transmit power. Given a desired EIRP of 21 dBm, and an antenna gain of 5.85 dBd connected through 25 feet of cable with a loss specification of 4 dB/100 feet.
Assuming that there is no significant loss from the connectors, what should be the transmit power level for this AP?

• A.14 mW
• B.25 mW
• C.10 mW
• D.20 mW

While configuring your site survey software for an upcoming manual survey project, you notice the configuration option for "Network Card Simu-lation". What is the purpose of such a feature and when would you use it?

• A.The site survey software manufacturer allows you to view the collected RF data as if it were collected by a different type of adapter. This functionality allows you to review survey data to determine how the RF environment will likely look based on the receive sensitivity and other RF capabilities of a specific client adapter.
• B.This setting allows the site survey software to convert the AP's measured downlink RF data into a simulated data set as if the same data were transmitted by a specific client station. It is useful for determining uplink client performance when clients are located far from APs as well as projecting cell size for ad hoc networks.
• C.This is the configuration area in which you specify the adapter type that will be used for the site survey so that the survey software can interpret that adapter's reported metrics (based on proprietary formulas) into an RF measurement that is standardized by the survey software and known to its users. This is done for every survey.
• D.Since WLAN adapters are not typically calibrated by manufacturers, this setting is a form of software calibration in which you can calibrate an (uncalibrated) adapter to match one of the calibrated adapters shown in the list. This process improves the reliability of RF data collection and reporting when uncalibrated adapters are used.