What wireless networking term describes the increase of RF energy in an intentional direction with the use
of an antenna?

• A.Directed Radiation
• B.Active Amplification
• C.Passive Gain
• D.Beam Digression

Comment: *

Name: *

Email: *

Verification: *

Which one of the following 802.11 PHYs is more likely to be used in an industrial deployment but not likely to be used in standard office deployments?

• A.OFDM
• B.SIG
• C.HT
• D.VHT

Comment: *

Name: *

Email: *

Verification: *

Your consulting firm has recently been hired to complete a site survey for a company. Your engineers use predictive design software for the task, but the company insists on a pre-deployment site visit.
What task should be performed as part of the pre-deployment visit to prepare for a predictive design?

• A.Evaluate the building materials at ABC's facility and confirm that the floor plan documents are consistent with the actual building
• B.Test several antenna types connected to the intended Aps for use in the eventual deployment
• C.Collect information about the company's security requirements and the current configuration of their RADIUS and user database servers
• D.Install at least one AP on each side of the exterior walls to test for co-channel interference through these walls

Comment: *

Name: *

Email: *

Verification: *

An 802.11 WLAN transmitter that emits a 50 mW signal is connected to a cable with 3 dB of loss.
The cable is connected to an antenna with 16 dBi of gain.
What is the EIRP power output?

• A.50 mW
• B.25 mW
• C.250 mW
• D.10 mW
• E.1000 mW

Comment: *

Name: *

Email: *

Verification: *

What ID is typically mapped to an AP's MAC address if a single BSS is implemented?

• A.BSSID
• B.VLAN ID
• C.SSID
• D.Device ID

Comment: *

Name: *

Email: *

Verification: *