Free Cisco 200-401 Exam Dumps Questions & Answers


Exam Code/Number:	200-401Join the discussion
Exam Name:	Managing Industrial Networks with Cisco Networking Technologies
Certification:	Cisco
Free Question Number:	64
Publish Date:	Aug 23, 2026
# of views:	3902
Rating 100%

Page: 1 / 13
Total 64 questions

Question 1

Exhibit: Refer to the exhibit. Which port should a PLC with IP address 192.168.3.65 be plugged into in order to communicate to the rest of the network?

A.FastEthernet1/1
B.FastEthernet1/3
C.FastEthernet1/4
D.FastEthernet1/2
E.FastEthernet1/5

Question 2

What are two symptoms of duplex mismatch? (Choose two.)

A.Communication is slow and locks up.
B.Ping does not return from one direction versus the other direction.
C.The half-duplex side sees frame sequence errors or runt frames.
D.Speed is seen equally slow in both directions.
E.The full-duplex side sees CRC errors.

Question 3

What is a characteristic of cables that are used in articulating equipment arms?

A.high flex rated cable
B.type PLTC cable
C.fiber-optic zip-cord construction
D.shielded copper twisted pair

Question 4

You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?

A.router#traceroute
B.router#ping
C.router#show ip route
D.router#show cdp neighbors
E.router#tracert

Question 5

Exhibit: Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)

A.IEEE1588 and PTP are important for ensuring real-time synchronization.
B.EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the same VLAN.
C.The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so shielded cable that is rated for 600 V is advised.
D.EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.
E.Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.
F.CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.