Free Cisco 300-080 Exam Dumps Questions & Answers

Refer to the exhibit.

Assume a centralized Cisco Unified Communications Manager topology with the headquarters at RTP and remote located at the U.K. All route patterns are assigned a route list that contains a route group pointing to the local gateway. RTP route patterns use the RTP gateway, and U.K. route patterns use the U.K. gateway.
When a U.K. user logs into an RTP phone using the Cisco Extension Mobility feature and places an emergency call to 0000, which statement about the emergency call is true?

• A.The call will match the RTP_Emergency route pattern partition and will egress at the RTP gateway.
• B.The call will fail.
• C.The call will match the RTP_Emergency route pattern partition and will egress at the U.K. gateway.
• D.The call will match the U.K_Emergency route pattern partition and will egress at the RTP gateway.
• E.The call will match the U.K_Emergency route pattern partition and will egress at the U.K. gateway.

You need to add transcoding support for g711alaw between two different sites. The current configuration is as follows:
dspfarm profile 1 transcode
codec g711 ulaw
codec g729ar8
codec g729abr8
codec g729br8
codec g729r8
maximum sessions 4
associate application SCCP
Which two steps do you need to take in order to add support for this codec? (Choose two)

• A.Add the command codec g711alaw followed by the command sccp.
• B.Issue the command no associate application SCCP.
• C.Add the command codec g711alaw
• D.Issue the command shutdown
• E.Disassociate the profile under the CCM group.

You are troubleshooting an ILS connectivity issue. All clusters are set to "Use TLS Certificates". Which certificates must be exchanged between Cisco Unified Communications Manager clusters?

• A.Tomcat certificates between publisher nodes in all clusters.
• B.TLS certificates between publisher nodes in all clusters.
• C.Tomcat certificates between all nodes in all clusters.
• D.Call Manager certificates between publisher nodes in all clusters.

Refer to the exhibit.

You are trying to establish a multipoint call via a Cisco TelePresence SX20 that is registered to Cisco Unified Communications Manager. When you attempt to bring a third party into the call, you receive an error that the call cannot be completed. You confirm that your MCU resources are configured correctly on Cisco Unified Communications Manager and that other devices are able to establish multipoint calls. What is the cause of this issue?

• A.The MCU is at capacity.
• B.The multipoint mode should be set to None.
• C.The multipoint mode should be set to Cisco Unified Communications Manager Resource Group.
• D.The call protocol should be H.323.
• E.The multipoint mode should be set to Multiway.

Cisco TelePresence System EX90-A and EX90-B are in a call. EX90-A tries to call EX90-C. When the call is dialed, EX90-B is put on hold. EX90-A and EX90-C are connected, but there is no merge button on the touch panel. What is causing this issue?

• A.The multipoint option key is missing.
• B.CiscoTelePresence systems cannot make multipoint calls without a Cisco TelePresence Server.
• C.The conference option key is missing.
• D.The multisite option key is missing.
• E.The conference configuration is missing.
• F.The multisite configuration is missing.