Free Cisco 300-180 Exam Dumps Questions & Answers

Refer to the exhibit.

You configure a Cisco Nexus 5000 in NPV mode to enable multiple servers to log in over a single link to the NPIV switch. Which option describes why the interface is stuck on the "initializing" state?

• A.The Cisco Nexus 5000 switch does not have "feature npv" enabled
• B.The load balancing is configured incorrectly on the Cisco Nexus 5000 switch.
• C.The version of code does not support the NPV feature
• D.The upstream switch does not have "feature npiv" enabled.

Two fabric interconnects fail during a Cisco UCS firmware upgrade. Drag and drop the recovery steps from the left into the correct order on the right.

Correct Answer:

Refer to the exhibit.

When your customers have NPV problems, which two actions should you
take? (Choose two.)

• A.Ensure that the VLAN values are configured on both sides of the NPV core switch.
• B.For all the device links, ensure that the port mode on the NPV device is in Full_port mode.
• C.Ensure that the VSAN value that is configured on the device links is correct
• D.Verify that the NPV core switch supports NPIV and that it is enabled
• E.Verify the status of the servers and external interfaces, using the show npv server status command

Which occurrence happens during an ISSU in a single supervisor configuration?

• A.The time-to-live value for CDP is increased (360 seconds) if it is less than the recommended timeout value
• B.NTP sessions stay alive and active
• C.The control plane is offline for up to 300 seconds
• D.FLOGI/fdisc or logo requests from servers fail until the ISSU is complete.

Refer to the exhibit.

All the interfaces on the switch must forward traffic by using VLAN 701.
Which action do you take?

• A.Increase the switch priority such that it becomes the spanning tree root
• B.Lower the switch priority such that it becomes the spanning tree root
• C.Enable the vPC on port channel 1101 and port channel 1102
• D.Allow VLAN 701 on port channel 1101 and port channel 1102