Free Cisco 300-370 Exam Dumps Questions & Answers

Refer to the exhibit.

Which statement about the join process of the access point is true?

• A.The AP moved from this controller to its primary controller.
• B.The time on the controller is outside of the certificates validity time interval, so the join phase failed.
• C.The AP failed to join because the self-signed certificate of the AP on the controller was not correct.
• D.The controller rejected most of the discovery requests from the AP because they were not received on the management interface subnet. The AP failed to join the controller.
• E.The AP successfully joined the controller.

Refer to the exhibit.

When you analyze the spectrum, you find some interference from a non-802.11 device. Which device is causing the interference based on the spectrum capture?

• A.DECT phone
• B.video camera
• C.microwave oven
  Microwave Oven If you look at the image below you can see a poorly shielded microwave that is disrupting almost the entire 2.4Ghz spectrum. Notice that the interference isn't persistence, but transient.
• D.Bluetooth

Refer to the exhibit. Which configuration must be addresses to correct this issue?

• A.AP authorization list
• B.Network Time Protocol
• C.DHCP Option 43
• D.self-signed certificate

Access points ate deployed in an office building and users report that the real-time communications quality of experience is poor when users walk between the elevators The elevators are a heavy metallic obstacle, and AP 3 was installed to cover the elevator area, which AP t and AP 2 signal does not reach Communications are captured for a user walking from point A to point C. and it is observed that the user iPhone device suddenly scans all bands and then roams from AP I to AP 3 somewhere between points B and C WLAN is set to 5 GHz only. Open, default rate configuration. Which action improves the real-time application quality of experience in this area?
Refer to the exhibit.

• A.Move AP 2 to point B
• B.Enable 802 11k on the WLAN
• C.Enable 802 11v on the WLAN
• D.Enable 802 11r on the WLAN

Refer to the exhibit.

Access points are deployed in an office building and users report that the real-time communications quality of experience is poor when users walk between the elevators. The elevators are a heavy metallic obstacle, and AP 3 was installed to cover the elevator area, which AP 1 and AP 2 signal does not reach. Communications are captured for a user walking from point A to point C, and it is observed that the user's iPhone device suddenly scans all bands and then roams from AP 1 to AP 3 somewhere between points B and C.
WLAN is set to 5 GHz only, Open, default rate configuration.
Which action improves the real-time application quality of experience in this area?

• A.Change WLAN security to WPA2/PSK.
• B.Enable 802.11v on the WLAN.
• C.Enable Client Band Select on the WLAN.
• D.Move AP 2 to point B.