An engineer has deployed a group of APs in an auditorium and notices that the APs are showing high cochannel interference. Which profile can be used to adjust the parameters for these high-density APs?

• A.QoS profile
• B.AVC profile
• C.RF profile
• D.ISE profile

Correct Answer: C

Comment: *

Name: *

Email: *

Verification: *

An engineer has deployed a group of APs in an auditorium and notices that the APs are showing high cochannel interference. Which profile can be used to adjust the parameters for these high-density APs?

• A.QoS profile
• B.AVC profile
• C.RF profile
• D.ISE profile

Correct Answer: C

Comment: *

Name: *

Email: *

Verification: *

A customer called with a requirement that internal clients must be on different subnets depending on the building they are in All access points are operating in local mode and will not be modified, and this is a single controller solution Which design approach creates the desired result?

• A.Create AP groups for each desired location, map the correct VLANs to the internal SSlD and add the access prints for that location
• B.Create an SSID. place it to the desired VLAN under WLANs. and configure 802.ix in ISE to assign the correct VLAN based on the SSlD from which the client is authenticating.
• C.Create mobility anchors for the SSID. and on the controller under the internal SSID. create a foreign map to the desired VLAN based on location
• D.Create FiexConnect groups, place the access points in. and set the correct VLAN to SSlD mapping based on location.

Comment: *

Name: *

Email: *

Verification: *

A wireless engineer must design mobility between two buildings at a campus site. The engineer has one controller at each site. The engineer is investigating inter-controller CAPWAP data and control traffic. Which two ports must be open? (Choose two.)

• A.16667
• B.5247
• C.8443
• D.5246
• E.16666

Comment: *

Name: *

Email: *

Verification: *

A company has 10 access point licenses available on their backup Cisco WLC and their primary Cisco WLC is at full capacity, 5 access points are set to high failover priority and 7 access points are set to critical failover priority. During a failure, not all critical access points failed over to the backup Cisco WLC. Which configuration is the cause of this issue?

• A.The high priority access point is oversubscribed.
• B.network ap-priority is set to enable.
• C.The critical priority access point count is oversubscribed.
• D.network ap-priority is set to disable.

Comment: *

Name: *

Email: *

Verification: *