The network engineering group of a large ISP needs to harden the management plane of its Cisco 9000 Series ASRs. While addressing IPv6 ICMP issues, they realized they have to limit the rate at which IPv6 ICMP error messages are sent out on the network. Which command do they need to apply?

• A.icmp ipv6 rate-limit unreachable 1000
• B.ipv6 rate-limit 1000
• C.icmp ipv4 rate-limit unreachable 1000
• D.ipv6 icmp error-interval 50 20

Comment: *

Name: *

Email: *

Verification: *

Which tool identifies the point of failure in a P2MP LSP from the ingress LSR?

• A.Jitter TLV
• B.SPAN
• C.P2MP traceroute
• D.P2MP ping

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which statement describes the result of this configuration?

• A.R1 redistributes BGP routes into the OSPF process of VRF custabc as E2 routes.
• B.R1 redistributes BGP routes into the OSPF process of VRF custabc as E1 routes.
• C.R1 redistributes BGP routes into the OSPF process of VRF custabc as OIA routes.
• D.R1 mutually redistributes routes between BGP 65001 and the OSPF process of VRF custabc.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. Which statement about this configuration is true?

• A.Router 1 will accept multicast routes with a route-target of 12:1.
• B.192.168.1.2 must be reachable by all routers participating in the mvpn-intranet MVRF.
• C.Router 1 has statically defined thresholds for data MDT.
• D.The MVRF must be configured on each router on the customer and service provider networks.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is trying to configure an EVPN VWPS. What is the issue with this configuration?

• A.The member in the VPWS context should be the PE-facing interface.
• B.The 12vpn evpn command should be instance 101.
• C.Interface GigabitEthernet0/1/0 should not have any IP address.
• D.The service instance and the EVPN instance are different.

Comment: *

Name: *

Email: *

Verification: *