Free Cisco 300-615 Exam Dumps Questions & Answers

A fabric interconnect fails to start and the console displays the loader prompt. Which two actions resolve the issue? (Choose two.)

• A.Load the correct version of the boot image.
• B.Reformat the fabric interconnect.
• C.Load an uncorrupt kickstart image.
• D.Load an uncorrupt bootloader image.
• E.Reconnect L1/L2 cables between the Fis.

Refer to the exhibit. UCS-1 fails to connect to the storage array. Which action resolves the issue?

• A.Enable N9K-1 mode to N-Port ID Virtualization.
• B.Set the FI-A mode to FC End Host mode.
• C.Configure N-Port ID Virtualization on FI-A.
• D.Implement N-Port Mirtualization on N9K-1.

Refer to the exhibit. A Cisco VXLAN must use bidirectional PIM so that:
- Spine2 is the active RP for multicast group 225.0.0.0/24.
- Loopback 254 is used as a logical interface for PIM configuration.
After configuration was applied, Spine1 became the active RP for multicast group 225.0.0.0/24 instead of Spine2. Which action resolves the issue?

• A.Change the IP address of Loopback 254 to 10.254.254.254 on Spine2.
• B.Configure the IP pim ssm range 232.0.0.0/8 on Spine1.
• C.Modify the subnet mask of Loopback 254 to /30 on Spine2.
• D.Delete the bidir keyword from ip pim rp address command on Spine1.

Refer to the exhibit. The HSRP instance on both switches is showing as active.
Which action resolves the issue?

• A.Allow VLAN 100 between the switches.
• B.Configure the HSRP timers to be the same.
• C.Configure the IP address of N9K-B on the same subnet as N9K-A.
• D.Configure preempt on only one of the switches.

Refer to the exhibit. Server 1 and Server 2 are bare-metal Windows-based servers and can exchange ICMP PING messages. However, both servers fail to ping their default gateway. Which action resolves the problem?

• A.Assign the NIC to the pin group.
• B.Set the native VLAN ID to 10.
• C.Disable Fabric Failover.
• D.Change the MTU value of the server.