A storage administrator is upgrading Cisco NX-OS on a Cisco MDS switch. The administrator performs an ISSU upgrade following the configuration guide. While the install is proceeding, the administrator connects a new server to the switch, which cannot access storage. The existing servers continue to operate properly through the switch. Why is the new server failing to connect?

• A.The fabric data plane resets as part of the upgrade process.
• B.The upgrade process disables any currently unused ports.
• C.The zoning database is locked during the upgrade process.
• D.The new server is unable to log in to the fabric to receive an FC-ID.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A storage network engineer gets remote access to two Cisco MDS 9000 Series Switches with an ISL trunk and receives several log messages. Which set of actions resolve the problem while least affecting service?

• A.1. Add :11:11:11:11:11:11:11:13 pwwn in zone Server11 and activate Zoneset10-A on MDS-A.
  2. Remove VSAN 10 from the allowed VSAN range of interface fc1/11 on MDS-A and add it back in the range.
• B.1. Explicitly import zone set Zoneset10-A on MDS-B using the zoneset import interface import fc1/11 vsan 10 command.
  2. Activate the zone set Zoneset10-A.
• C.1. Add :11:11:11:11:11:11:11:13 pwwn in zone Server11 and activate Zoneset10-A on MDS-A.
  2. shut/no shut interface fc1/11 on MDS-A.
• D.1. Deactivate zone set Zoneset10-A on MDS-A.
  2. shut/no shut interface fc1/11 on MDS-A.

Comment: *

Name: *

Email: *

Verification: *

Which configuration is available only in Cisco DCNM-SAN Advanced mode?

• A.IVR
• B.VMpath configuration
• C.zoning
• D.template-based provisioning

Comment: *

Name: *

Email: *

Verification: *

A storage administrator is connecting two previously configured switches to make a single fabric. When the E Ports are connected, the administrator sees a ZONE MERGE FAILURE message referring to the zoneset for VSAN 10 on each switch. Which command should the administrator use to allow these switches to work together?

• A.zoneset distribute full vsan 10
• B.zoneset overwrite-control vsan 10
• C.zoneset import interface fc1/1 vsan 10
• D.zoneset copy active-zoneset full-zoneset

Comment: *

Name: *

Email: *

Verification: *

Which command identifies the application and the user that have a Cisco Fabric Services session open?

• A.show device-alias database
• B.show cfs lock
• C.show cfs application
• D.show zoneset active

Comment: *

Name: *

Email: *

Verification: *