An engineer is troubleshooting application failures through an FTD deployment. While using the FMC CLI, it has been determined that the traffic in question is not matching the desired policy. What should be done to correct this?

• A.Use the system support firewall-engine-debug command to determine which rules the traffic matching and modify the rule accordingly.
• B.Use the system support firewall-engine-dump-user-identity-data command to change the policy and allow the application though the firewall.
• C.Use the system support application-identification-debug command to determine which rules the traffic matching and modify the rule accordingly.
• D.Use the system support network-options command to fine tune the policy.

Comment: *

Name: *

Email: *

Verification: *

When do you need the file-size command option during troubleshooting with packet capture?

• A.when capture packets are less than 16 MB
• B.when capture packets are restricted from the secondary memory
• C.when capture packets exceed 10 GB
• D.when capture packets exceed 32 MB

Comment: *

Name: *

Email: *

Verification: *

An engineer currently has a Cisco FTD device registered to the Cisco FMC and is assigned the address of 10 10.50.12. The organization is upgrading the addressing schemes and there is a requirement to convert the addresses to a format that provides an adequate amount of addresses on the network What should the engineer do to ensure that the new addressing takes effect and can be used for the Cisco FTD to Cisco FMC connection?

• A.Format and reregister the device to Cisco FMC.
• B.Update the IP addresses from IPV4 to IPv6 without deleting the device from Cisco FMC
• C.Cisco FMC does not support devices that use IPv4 IP addresses.
• D.Delete and reregister the device to Cisco FMC

Comment: *

Name: *

Email: *

Verification: *

Which two routing options are valid with Cisco Firepower Threat Defense? (Choose two.)

• A.BGPv6
• B.ECMP with up to three equal cost paths across multiple interfaces
• C.ECMP with up to three equal cost paths across a single interface
• D.BGPv4 in transparent firewall mode
• E.BGPv4 with nonstop forwarding

Comment: *

Name: *

Email: *

Verification: *

Which command is entered in the Cisco FMC CLI to generate a troubleshooting file?

• A.show running-config
• B.show tech-support chassis
• C.system support diagnostic-cli
• D.sudo sf_troubleshoot.pl

Comment: *

Name: *

Email: *

Verification: *