Which protocol establishes network redundancy in a switched Firepower device deployment?

• A.STP
• B.HSRP
• C.GLBP
• D.VRRP

Comment: *

Name: *

Email: *

Verification: *

A network engineer is extending a user segment through an FTD device for traffic inspection without creating another IP subnet How is this accomplished on an FTD device in routed mode?

• A.by leveraging the ARP to direct traffic through the firewall
• B.by assigning an inline set interface
• C.by using a BVI and create a BVI IP address in the same subnet as the user segment
• D.by bypassing protocol inspection by leveraging pre-filter rules

Comment: *

Name: *

Email: *

Verification: *

A security engineer is configuring a remote Cisco FTD that has limited resources and internet bandwidth. Which malware action and protection option should be configured to reduce the requirement for cloud lookups?

• A.Block Malware action and local malware analysis
• B.Malware Cloud Lookup and dynamic analysis
• C.Block Malware action and dynamic analysis
• D.Block File action and local malware analysis

Comment: *

Name: *

Email: *

Verification: *

A company is in the process of deploying intrusion prevention with Cisco FTDs managed by a Cisco FMC. An engineer must configure policies to detect potential intrusions but not block the suspicious traffic. Which action accomplishes this task?

• A.Configure IPS mode when creating or editing a policy rule under the Cisco FMC Intrusion tab in Access Policies section by checking the "Drop when inline" option.
• B.Configure IPS mode when creating or editing a policy rule under the Cisco FMC Intrusion tab in Access Policies section by unchecking the "Drop when inline" option.
• C.Configure IDS mode when creating or editing a policy rule under the Cisco FMC Intrusion tab in Access Policies section by checking the "Drop when inline" option.
• D.Configure IDS mode when creating or editing a policy rule under the Cisco FMC Intrusion tab in Access Policies section by unchecking the "Drop when inline" option.

Comment: *

Name: *

Email: *

Verification: *

What are the minimum requirements to deploy a managed device inline?

• A.inline interfaces, security zones, MTU, and mode
• B.passive interface, MTU, and mode
• C.inline interfaces, MTU, and mode
• D.passive interface, security zone, MTU, and mode

Comment: *

Name: *

Email: *

Verification: *