Free Cisco 350-080 Exam Dumps Questions & Answers

Which statement describes OTV configuration on the Cisco Nexus 7000 Series Switches?

• A.The OTV internal interface encapsulates the site Layer 2 frames in IP unicast or multicast packets that are then sent to the other sites.
• B.The OTV join interface is a routed uplink interface on the edge device used to physically join the overlay network.
• C.OTV uses an SSM group range for neighbor discovery and to exchange MAC reachability with other OTV edge peers.
• D.The OTV control-plane protocol uses the IS-IS protocol to establish adjacencies and exchange MAC reachability across the overlay network. You must enable IS-IS with the feature isis command before OTV adjacencies can be established.

DRAG DROP

Correct Answer:

Which three statements describe the configuration change management feature in DCNM LAN? (Choose three.)

• A.DCNM LAN can archive configurations from devices even if they are not managed by the DCNM server, and the administrator can supply the device management IP address and credentials.
• B.Managed devices must be licensed in DCNM LAN before they can be used with configuration change management.
• C.You can archive a maximum of 50 configuration versions per managed device.
• D.Device-running configuration will be archived only if it differs from the last archived version.
• E.Switch profiles allow configurations to be synchronized between switches and are supported with any Cisco NX-OS Software managed device.

Refer to the exhibit.

Which type of address-port translation is shown?

• A.server NAT
• B.dual NAT
• C.port redirection
• D.transparent mode

Which statement about the SAN Extension Tuner is true?

• A.The data pattern that is used for the data that is generated between the virtual N Ports can be an all-zero pattern or an all-ones pattern. No other data patterns can be used.
• B.The virtual N Ports that are created will register the FC4 features that are supported with the name server.
• C.The SET configuration is persistent across reboots.
• D.Only SCSI read and write commands are implemented.
• E.SET cannot be used if iSCSI is enabled.