In cisco SD_WAN, which protocol is used to measure link quality?

• A.OMP
• B.BFD
• C.RSVP
• D.IPsec

Comment: *

Name: *

Email: *

Verification: *

AN engineer is implementing MPLS OAM to monitor traffic within the MPLS domain. Which action must the engineer perform to prevent from being forwarded beyond the service provider domain when the LSP is down?

• A.Implement the destination address for the LSP echo request packet in the 127.x.y.z/8 network
• B.Disable IP redirects only on outbound interfaces
• C.Disable IP redirects on all ingress interfaces
• D.Configure a private IP address as the destination address of the headend router of Cisco MPLS TE.

Comment: *

Name: *

Email: *

Verification: *

After a redundant route processor failure occurs on a Layer 3 device, which mechanism allows for packets to be forwarded from a neighboring router based on the most recent tables?

• A.RPVST+
• B.BFD
• C.NSF
• D.RP failover

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer is troubleshooting a connectivity issue and executes a traceoute. What does the result confirm?

• A.The destination server reported it is too busy
• B.The protocol is unreachable
• C.The destination port is unreachable
• D.The probe timed out

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit. A network engineer must configure NETCONF. After creating the configuration, the engineer gets output from the command show line, but not from show running-config. Which command completes the configuration?

• A.Option D
• B.Option B
• C.Option A
• D.Option C

Comment: *

Name: *

Email: *

Verification: *