Which two methods are used to reduce the AP coverage area? (Choose two)

• A.Enable Fastlane
• B.Disable 2.4 GHz and use only 5 GHz.
• C.Reduce channel width from 40 MHz to 20 MHz
• D.Increase minimum mandatory data rate
• E.Reduce AP transmit power.

Comment: *

Name: *

Email: *

Verification: *

What occurs when a high bandwidth multicast stream is sent over an MVPN using Cisco hardware?

• A.A data MDT is created to allow for the best transmission through the core for (S, G) multicast route entries.
• B.A data and default MDT are created to flood the multicast stream out of all PIM-SM neighbors.
• C.A data MDT is created to if it is a (*, G) multicast route entries
• D.The traffic uses the default MDT to transmit the data only if it isa (S,G) multicast route entry

Comment: *

Name: *

Email: *

Verification: *

A company has an existing Cisco 5520 HA cluster using SSO. An engineer deploys a new single Cisco Catalyst 9800 WLC to test new features. The engineer successfully configures a mobility tunnel between the
5520 cluster and 9800 WLC. Client connected to the corporate WLAN roam seamlessly between access points on the 5520 and 9800 WLC. After a failure on the primary 5520 WLC, all WLAN services remain functional; however, Client roam between the 5520 and 9800 controllers without dropping their connection. Which feature must be configured to remedy the issue?

• A.new mobility on the 5520 cluster
• B.mobility MAC on the 5520 cluster
• C.mobility MAC on the 9800 WLC
• D.new mobility on the 9800 WLC

Comment: *

Name: *

Email: *

Verification: *

Refer to Exhibit.

MTU has been configured on the underlying physical topology, and no MTU command has been configured on the tunnel interfaces. What happens when a 1500-byte IPv4 packet traverses the GRE tunnel from host X to host Y, assuming the DF bit is cleared?

• A.The packet arrives on router C without fragmentation.
• B.The packet is discarded on router A
• C.The packet is discarded on router B
• D.The packet arrives on router C fragmented.

Correct Answer: D

Explanation
Text Description automatically generated

Comment: *

Name: *

Email: *

Verification: *

What is used to perform OoS packet classification?

• A.the Options field in the Layer 3 header
• B.the Type field in the Layer 2 frame
• C.the Flags field in the Layer 3 header
• D.the TOS field in the Layer 3 header

Comment: *

Name: *

Email: *

Verification: *