What is required for intercontroller Layer 3 roaming?

• A.WLCs use separate DHCP servers.
• B.Mobility groups are established between wireless controllers.
• C.The management VLAN is present as a dynamic VLAN on the second WLC.
• D.WLCs have the same IP addresses configured on their interfaces.

Comment: *

Name: *

Email: *

Verification: *

A GRE tunnel is down with the error message %TUN-5-RECUR DOWN:

Which two options describe possible causes of the error? (Choose two)

• A.There is link flapping on the tunnel
• B.Incorrect destination IP addresses are configured on the tunnel
• C.The tunnel mode and tunnel IP address are misconfigured
• D.There is instability in the network due to route flapping
• E.The tunnel destination is being routed out of the tunnel interface

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

What is the Json syntax that is formed from the data?

• A.Name: Bob Johnson, Age: 75, Alive': true, Favourite Foods: [Cereal, Mustard, Onions]}
• B.Name: Bob Johnson, Age: 75, Alive': true, Favourite Foods: Cereal Mustard Onions
• C.Name: Bob Johnson, Age: 75, Alive': true, Favourite Foods: ['Cereal'', ''Mustard'', ''Onions]}
• D.Name: Bob Johnson, Age: seventy-five, Alive': true, Favourite Foods: [Cereal, Mustard, Onions]}

Correct Answer: C

Comment: *

Name: *

Email: *

Verification: *

Drag and drop the LISP components on the left to the correct description on the right

Correct Answer:

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_lisp/configuration/xe-3s/irl-xe-3s-book/irloverview.html#GUID-92481C7B-F44D-4D8C-8085-A2E98530CA50

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEthemet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two)

• A.Router(config-if)Cip address 192.168.1.1 255.255.255.0
• B.Router(config-vrf)#address-family ipv6
• C.Router(config-vrf)Sip address 192.168.1.1 255.255.255.0
• D.Router(config-if)=address-family ipv4
• E.Router(config-vrf)#address-family ipv4

Comment: *

Name: *

Email: *

Verification: *