What is the wireless received signal strength indicator?

• A.The value given to the strength of the wireless signal received compared to the noise level
• B.The value of how strong the wireless signal Is leaving the antenna using transmit power, cable loss, and antenna gain
• C.The value of how much wireless signal is lost over a defined amount of distance
• D.The value of how strong a tireless signal is receded, measured in dBm

Comment: *

Name: *

Email: *

Verification: *

Which two components are supported by LISP? (choose two )

• A.proxy ETR
• B.egress tunnel router
• C.route reflector
• D.HMAC algorithm
• E.spoke

Comment: *

Name: *

Email: *

Verification: *

Which two statements about IP SLA are true? (Choose two)

• A.SNMP access is not supported
• B.It uses active traffic monitoring
• C.It is Layer 2 transport-independent
• D.The IP SLA responder is a component in the source Cisco device
• E.It can measure MOS
• F.It uses NetFlow for passive traffic monitoring

Comment: *

Name: *

Email: *

Verification: *

An engineer creates the configuration below. Drag and drop the authentication methods from the left into the order of priority on the right. Not all options are used.

Correct Answer:

Explanation

Comment: *

Name: *

Email: *

Verification: *

What are two features of NetFlow flow monitoring? (Choose two.)

• A.Can track ingress and egress information
• B.Include the flow record and the flow importer
• C.Copies all ingress flow information to an interface
• D.Does not required packet sampling on interfaces
• E.Can be used to track multicast, MPLS, or bridged traffic.

Comment: *

Name: *

Email: *

Verification: *