Free Cisco 350-501 Exam Dumps Questions & Answers

Refer to the exhibit. Customer_A asked ISP_A to connect two offices via an MPLS L3 VPN.
Customer_A is currently using only the default route toward ISP_A. The engineer at ISP_A already configured the ip route vrf Customer_A 172.16.10.0 255.255.255.0 10.10.10.1 command on R1. Which action completes the configuration?

• A.Configure the redistribute static and redistribute connected commands on R1.
• B.Configure the network 172.16.10.0 and redistribute-internal static commands under the BGP address family for Customer_A in the global BGP configuration on R1.
• C.Configure the route-target both 200:1 and route-replicate vrf Customer_A commands under the ip vrf configuration on R2.
• D.Enable the bgp default route-target filter and default-information originate commands under the global BGP configuration on R2.

Refer to the exhibit. The CE router is peering with both PE routers and advertising a public prefix to the internet. Routing to and from this prefix will be asymmetric under certain network conditions, but packets must not be discarded. Which configuration must an engineer apply to the two PE routers so that they validate reverse packet forwarding for packets entering their Gi2 interfaces and drop traffic from the RFC1918 space?

• A.interface GigabitEthernet 2
  ip verify unicast source reachable-via rx
• B.ip verify unicast source reachable-via any
• C.ip verify unicast source reachable-via rx allow-default
• D.ip verify unicast source reachable-via any allow-default
  interface GigabitEthernet 2

Refer to the exhibit. A network engineer is implementing an LDP-based MPLS solution to enable packet flow between the two bank sites. The engineer was given two requirements:
- LDP peering must stay up when there is a link failure between R3 and
R6
- LDP peering must not flap when there is a link failure between R5 and R6 Which action meets these requirement?

• A.Configure LDP Session Protection on R4.
• B.Implement an LDP targeted session with R4 on R6.
• C.Reset the LDP session between R4 and R6.
• D.Enable Link LDP on R4 and R6.

Refer to the exhibit. The networking team recently identified a folder of archived scripts in an internal repository. A junior engineer must determine whether any of the scripts are useful in the current network environment. What is the primary purpose of this script?

• A.collecting information about network devices
• B.storing a token to the local device repository
• C.provisioning a new device with a hostname and device ID
• D.using a function loop to configure a group of network devices

Which capability does RSVP provide in an MPLS network?

• A.supporting interoperability between IntServ and DiffServ architecture models
• B.reserving bandwidth for multicast flows
• C.reserving up to 75% of interface bandwidth by default
• D.signaling a primary path for LSP tunnels