Refer to the exhibit. After implementing a new design for the network, a technician reviews the pictured CLI output as part MOP. Which two outcomes will be technician ascertain from the impNull output? (Choose two.)

• A.Penultimate Hop Popping is in use for the prefix displayed
• B.Label 0 is used for the prefix displayed but will not be part of the MPLS label stack for packets destined for 192 168.10.10.
• C.Label 3 is in use for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10
• D.Label 0 is used for the prefix displayed and will be part of the MPLS label stack for packets destined for
  192.168.10.10
• E.Ultimate Hop Popping is in use for the prefix displayed.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS deployment Assume that the AToM L2VPN service that connects the two CEs is configured correctly on the service provider network Which action causes the solution to fail?

• A.The x connect statement has not been defined
• B.The routing protocol network types are not compatible
• C.A loopback with a /32 IP address has not been used
• D.OSPF does not work with L2VPN services

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit:

What is the URL used for with REST API?

• A.It is used to initiate an FTP session to save a running configuration of a device.
• B.It is used to send a TACACS+ authentication request to a server
• C.It is used to contact a URL filter to determine the efficacy of a web address
• D.It is used to send a message to the APIC to perform an operation on a managed object or class operator

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit:

Which three outcomes occur if the prefix list is added to the neighbor? (Choose three)

• A.192.168 0.0/17 is permitted
• B.192.168 0.0/17 is denied.
• C.192.168 0.0/16 is permitted
• D.192.168 0.0/19 is denied.
• E.192.168.0.0/16 is denied
• F.192.168 0.0/19 is permitted

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An engineer has started to configure a router for OSPF, as shown Which configuration must an engineer apply on the network so that area 15 traffic from R5 to R1 will prefer the route through R4?

• A.Increase the cost on the link between R2 and R4, to influence the path over R3 and R4.
• B.Place the link between R3 and R5 in a stub area to force traffic to use the route through R4.
• C.Implement a sham link on the between R3 and R2 to extend area 0 area 15.
• D.Implement a multiarea adjacency on the link between R2 and R4, with the cost manipulated to make the path through R4 preferred.

Comment: *

Name: *

Email: *

Verification: *