A network is designed to use OSPF to reach eBGP peers. For eBGP peers to stay stable in case of a link failure, what condition should be avoided?

• A.Advertise IP addresses used on eBGP peer statements via eBGP
• B.Use an ACL to block BGP in one direction
• C.Advertise IP addresses used on eBGP statements via a normal OSPF area
• D.Disable BGP synchronization

Comment: *

Name: *

Email: *

Verification: *

You are the Cisco Network Designer in P4S. What is the
term for a logical SAN which provides isolation among devices physically connected to the same fabric?

• A.InterSwitch Link
• B.Virtua LAN
• C.Virtual Output Queuing
• D.virtual storage area network

Comment: *

Name: *

Email: *

Verification: *

A network designer decides to connect two labs together to test multicast features interoperability. Before the networks are connected together, the network administrator mentions that overlapping multicast IP addresses between the two labs will cause issues because all the routers on the network are provisioned for Source-Specific Multicast using IGMPv3. Which statement about the connectivity of both multicast domains is true?

• A.IGMPv3 requires a unique RP when connecting both labs together
• B.IGMPv3 cannot support overlapping multicast IP addresses between the labs
• C.IGMPv3 requires NAT to support the overlapping multicast IP addresses between the labs
• D.IGMPv3 can support overlapping multicast IP addresses between the labs

Comment: *

Name: *

Email: *

Verification: *

How are community formats sent in SNMPv1 and SNMPv2c?

• A.In both protocols they are sent as clear text.
• B.In both protocols they are encrypted.
• C.In SNMPv1 they are sent as clear text and in SNMPv2c they are sent as part of an encrypted session.
• D.In SNMPv1 they are sent as clear text and in SNMPv2c they are encrypted.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

If IEEE 802.1w is in use for this network design, what are two locations where spanningtree root can be placed to ensure the least-disruptive Layer 2 failover for clients within VLANs 3 and 4?
(Choose two.)

• A.Switch C
• B.Switch B
• C.Switch D
• D.Switch A

Comment: *

Name: *

Email: *

Verification: *