Refer to the exhibit.

Your junior design engineer presents this configuration design. What is the next-hop router for CE3, and why?

• A.CE1. HSRP on CE1 is in active state.
• B.CE2. The link between CE2 and PE1 has more bandwidth than CE1-to-PE1.
• C.CE2. EBGP administrative distance is lower than RIP.
• D.CE1. BGP weight is higher than CE2.

Comment: *

Name: *

Email: *

Verification: *

What are three advantages of using ISATAP? (Choose three.)

• A.It does not require any changes on the underlying IPv4 network to operate.
• B.It works with both private and public addressing spaces.
• C.It is easier to set up than other tunneling mechanisms, such as 6RD and 6to4.
• D.It is supported on many platforms, such as Linux, Windows, and Cisco IOS Software.
• E.It is a point-to-multipoint tunneling mechanism.

Comment: *

Name: *

Email: *

Verification: *

A metro service provider is planning Resilient Ethernet Protocol for his backbone. Which two aspects must be considered before the network design is finalized? (Choose two.)

• A.A Resilient Ethernet Protocol segment is limited to a maximum of seven devices.
• B.Two Resilient Ethernet Protocol segments can be connected redundantly at two points. One connection will be blocked, using the Spanning Tree Protocol defined in IEEE 802.1D.
• C.UniDirectional Link Detection Protocol can be enabled on Resilient Ethernet Protocol interfaces to detect unidirectional failures.
• D.VLAN load balancing for optimal bandwidth usage is supported in any Resilient Ethernet Protocol segment.
• E.The guaranteed convergence recovery time is less than 50 ms for the local segment.

Comment: *

Name: *

Email: *

Verification: *

What information can you get from TCP flags while assessing an attack?

• A.source of the attack
• B.type of attack
• C.target of the attack
• D.priority of the attack traffic

Comment: *

Name: *

Email: *

Verification: *

What is a key design aspect to be considered when designing an IP network that will be carrying real-time VoIP traffic?

• A.Minimizing total unidirectional end-to-end delay to 150-500 ms
• B.Minimizing total bidirectional end-to-end delay to 0-50 ms
• C.Minimizing total unidirectional end-to-end delay to 0-150 ms
• D.Minimizing total bidirectional end-to-end delay to 0-150 ms

Comment: *

Name: *

Email: *

Verification: *