Company XYZ needs advice in redesigning their legacy Layer 2 infrastructure.
Which technology should be included in the design to minimize or avoid convergence delays due to STP or FHRP and provide a loop-free topology?

• A.Use switch clustering in the access layer.
• B.Use BFD.
• C.Use spanning-tree PortFast.
• D.Use switch clustering in the core/distribution layer.

Comment: *

Name: *

Email: *

Verification: *

Company XYZ is planning to deploy primary and secondary (disaster recovery) data center sites. Each of these sites will have redundant SAN fabrics and data protection is expected between the data center sites. The sites are 100 miles (160 km) apart and target RPO/RTO are 3 hrs and 24 hrs, respectively. Which two considerations must Company XYZ bear in mind when deploying replication in their scenario? (Choose two.)

• A.Target RPO/RTO requirements cannot be met due to the one-way delay introduced by the distance between sites.
• B.VSANs must be routed between sites to isolate fault domains and increase overall availability.
• C.Synchronous data replication must be used to meet the business requirements
• D.Asynchronous data replication should be used in this scenario to avoid performance impact in the primary site.
• E.VSANs must be extended from the primary to the secondary site to improve performance and availability.

Comment: *

Name: *

Email: *

Verification: *

You are designing a network running both IPv4 and IPv6 to deploy QoS.
Which consideration is correct about the QoS for IPv4 and IPv6?

• A.Different congestion management mechanisms need to be used for IPv4 and IPv6 traffic types
• B.IPv6 and IB/4 traffic types can use a single QoS policy to match both protocols
• C.IPv4 and IPv6 traffic types can use use queuing mechanisms such as LLQ, PQ and CQ.
• D.IPv6 packet classification is only available with process switching, whereas IPv4 packet classification is available with both process switching and CEF.

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit A company has a hybrid cloud architecture with two on-premises data centers that connect to a public cloud service provider by using direct connect and eBGP routing. Encryption is unsupported by the cloud service provider, so the company plans to use an IPsec overlay network over its direct connects. Two virtual network appliances will be installed in the cloud infrastructure to establish tunnels and perform routing The company chose OSPF as the overlay routing protocol because the operations team is familiar with the protocol and because OSPF is the IGP on the on-premises network. The cloud network must be as isolated as possible from the on-premises network. What must be used for the OSPF overlay connectivity ?

• A.different OSPF instance. NVA as the ASBR
• B.different OSPF instance. Cloud Edge as the ASBR
• C.different OSPF area. Cloud Edge as the ABR
• D.different OSPF area. NVA as the ABR

Comment: *

Name: *

Email: *

Verification: *

A customer migrates from a traditional Layer 2 data center network into a new SDN-based spine-and-leaf VXLAN data center within the same location Its applications cannot be readdressed and the customer does not want to perform the migration in a single operation How should the legacy network and new network be connected?

• A.via Layer 3 links to border leaf switches
• B.via a Layer 2 trunk and Layer 3 routed links to spine switches
• C.via a Layer 2 trunk and Layer 3 routed links to border leaf switches
• D.via a Layer 2 trunk to border leaf switches

Comment: *

Name: *

Email: *

Verification: *