Free Cisco 640-692 Exam Dumps Questions & Answers

What is the difference between a CSU/DSU and a modem?

• A.A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.
• B.A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.
• C.A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.
• D.A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.

Refer to the exhibit.

Which three statements correctly describe Network Device A? (Choose three.)

• A.With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other.
• B.With a network wide mask of 255.255.254.0, each interface does not require an IP address.
• C.With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.
• D.With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.
• E.With a network wide mask of 255.255.255.128, each interface does not require an IP address.

Which of the following best describes how to assign a static IP address to the Ethernet port on a computer?

• A.Click Start> Run Enter cmd and click OK. Enter ip address XXX.XXX.XXX.XXX.
• B.From Network Connections, double-click Local Connection. Click Properties, click iPass Protocol (IEEE), click properties and select static IP.
• C.From network Connections, click Create a New Connection and follow the network connection Wizard instructions.
• D.From Network Connections, double-click Local Area Connection. Click Protocol (TCP/IP). Click the properties, click the use the Following Address button, and then configure the IP information.

Refer to the exhibit.

Into which port do you insert the card?

• A.Gigabit Ethernet
• B.Ethernet
• C.ATM
• D.Serial

Refer to the exhibit.

For what two reasons has the router loaded its IOS image from the location that is shown?
(Choose two.)

• A.Router1 is acting as a TFTP server for other routers.
• B.Cisco routers will first attempt to load an image from TFTP for management purposes.
• C.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
• D.Router1 cannot locate a valid IOS image in flash memory.
• E.Router1 has specific boot system commands that instruct it to load IOS from a TFTP server.