Free Cisco 644-906 Exam Dumps Questions & Answers

What is the cell size of the cells that traverse the switch fabric on the Cisco CRS-3?

• A.128 bytes
• B.144 bytes
• C.288 bytes
• D.200 bytes
• E.136 bytes

Which two commands will allow you to check if interface Bundle-Ether1 has ACL Ethernet_In applied to its ingress? (Choose two.)

• A.show ipv4 interface Bundle-Ether 1
• B.show running-config ipv4 access-list Ethernet_In
• C.show interface Bundle-Ether1 access-list
• D.show running-config interface Bundle-Ether 1
• E.show access-list ipv4 Ethernet_In

On a Cisco CRS, which statement is correct about what happens to the MSC if the associated PLIM is absent?

• A.The MSC does not boot up.
• B.The MSC boots up, but all egress packets from the switch fabric to this MSC will be dropped.
• C.The state of the MSC from the output of the command show platform would show as IOS XR RUN.
• D.The other PLIM in a different slot can utilize this MSC.

How many stages are there in the Cisco CRS-1 switch fabric?

• A.1
• B.8
• C.3
• D.None, as the Cisco CRS-1 does not use a switch fabric
• E.4

Refer to the exhibit.

Based on the configuration, which two statements are true for RTR1? (Choose two.)

• A.SNMP polling that is coming through interface TenGigE 0/0/0/0 will be dropped.
• B.The SSH connection that is coming through TenGigE 0/0/0/0 from host 5.5.5.5 will be accepted.
• C.SNMP traps that are going out on TenGigE 0/0/0/0 will be dropped.
• D.TACACS traffic that is originating from RTR1 and going through TenGigE 0/0/0/0 will be dropped.
• E.The Telnet connection that is coming through MgmtEth0/RSP0/CPU0/0 will be dropped.