Free Citrix 1Y0-440 Exam Dumps Questions & Answers

Which three methods can a Citrix Architect use to assess the capabilities of a network infrastructure? (Choose three.)

• A.Examine the topology for single points of failure and potential bottlenecks.
• B.Review existing monitoring solutions for periods of latency, lost packets, and insufficient bandwidth.
• C.Alter firewall rules of existing network to fit into the new NetScaler Deployment.
• D.Ensure that users and computers are in the correct organizational units (OUs).
• E.Map the location of the users against the existing network topology.

Scenario: Based on a discussion between a Citrix Architect and team of Workspacelab has been created across three (3) sites.
They captured the following requirements during the design discussion held for NetScaler design projects:
All three (3) Workspacelab sites (DC, NDR, and DR) will have similar NetScaler configuration and design.
Both external and internal NetScaler MPX appliances will have Global Server Load balancing (GSLB) configured and deployed in Active/Passive mode.
GSLB should resolve both A and AAA DNS queries.
In the GSLB deployment, the NDR site will act as backup for the DC site. whereas the DR site will act as backup for the NDR site.
When the external NetScaler replies to DNS traffic coming in through Cisco Firepower IPS, the replies should be sent back through the same path.
On the internal NetScaler, both front-end VIP and back-end SNIP will be part of the same subnet.
USIP is configured on the DMZ NetScaler appliances.
The external NetScaler will act default gateway for back-end servers.
All three (3) sites (DC, NDR, and DR) will have two (2) links to the Internet from different service providers configured in Active/Standby mode.
Which design decision must the architect make to meet the design requirements above?

• A.The SNIP of the external NetScaler must be configured as default gateway on the back-end servers.
• B.Interface 0/1 must be used for DNS traffic.
• C.Policy-Based Route with next hop as CISCO IPS must be configured on the external NetScaler.
• D.ADNS service must be used with IPv6 address.

Scenario: A Citrix Architect and a team of Workspacelab members met to discuss requirements during the design discussion for a Citrix ADC design project. Specifically, the existing Citrix ADC Configuration must be modified to meet the following authentication conditions:
* Provide users with domain drop-down page
* If the users select workspacelab.com. perform single factor authentication using LDAP
* It the users select AAATM.COM, perform two factor authentication using LDAP and RADIUS
* If the users select NSI-TEST. COM. perform SAML authentication using ADFS What should the architect use to bind the AAA virtual server to the Citrix Gateway virtual server?

• A.Form based binding
• B.Authentication Profile
• C.302 based redirect
• D.401 based binding

Which NetScaler Management and Analytics System (NMAS) utility can a Citrix Architect utilize to verify the configuration template created by the NMAS StyleBook, before actually executing it on the NetScaler?

• A.configpack
• B.Dry Run
• C.configcheck
• D.NITRO API

Scenario: A Citrix Architect has sent the following request to the NetScaler:

Which response would indicate the successful execution of the NITRO command?

• A.201
• B.202
• C.302
• D.200