Immediately following a BIOS firmware update, a server detects an overheat condition and shuts down after five minutes. Which of the following should the systems administrator do FIRST?

• A.Run the hardware manufacturer's onboard diagnostics
• B.Disconnect the server's power and restore the backup ROM
• C.Ensure the system fans are running
• D.Reapply thermal paste to the CPUs and heat sinks

Comment: *

Name: *

Email: *

Verification: *

A technician is responsible for overseeing twelve remote offices. There was a report of a power outage at one of the remote offices the night before, and now one of the servers there has not rebooted even though it was shut down gracefully. The technician was forced to travel two hours just to turn the server on. Which of the following is the MOST cost effective way to prevent future travel?

• A.Install an uninterruptible power supply (UPS) onsite.
• B.Install a remote management card in the server.
• C.Install a generator onsite.
• D.Move the server to the main office.

Comment: *

Name: *

Email: *

Verification: *

While reviewing a network connectivity issue to a Linux server, the systems administrator issues the ifconfigcommand with the following results:

According to the output above, which of the following is the problem?

• A.The adapter is not in an "UP" state
• B.The broadcast address is incorrect
• C.The adapter is in "BROADCAST" mode
• D.The netmask is incorrectly configured

Comment: *

Name: *

Email: *

Verification: *

An email administrator is tasked to set up a Linux mail server. One of the requirements is to close all ports except SSH, HTTPS, SMTP, POP3, and IMAP4. Which of the following commands should be used to see which ports are currently open on the email server? (Choose two.)

• A.traceroute
• B.ipconfig
• C.ping
• D.netstat
• E.dig

Comment: *

Name: *

Email: *

Verification: *

Which of the following must be done to properly conduct testing of the data backup portion of a disaster recovery plan?

• A.Perform an integrity test of backup media.
• B.Restore backed up data to a test server.
• C.Verify that backups have occurred and were successful via the logs.
• D.Verify data on backup media can be read.

Comment: *

Name: *

Email: *

Verification: *