Free Dell DCAPE-100 Exam Dumps Questions & Answers


Exam Code/Number:	DCAPE-100Join the discussion
Exam Name:	Dell PowerEdge Associate Exam
Certification:	Dell
Free Question Number:	55
Publish Date:	Jul 06, 2026
# of views:	3162
Rating 100%

Page: 1 / 11
Total 55 questions

Question 1

A systemboard was replaced. After the replacement, the system will NOT boot into Windows and gives the error 'No boot device found'. Virtual disks are seen and optimal.
What action should a technician take to resolve this issue?

A.Make sure that the iDRAC license was imported
B.Reseat the RAID chain
C.Change the boot settings from BIOS to UEFI
D.Insert the Windows media to fix the MBR

Question 2

A server is configured with a RAID 5 Virtual Disk across 5 hard disks and 1 spare disk. If a hard disk failure occurs within the RAID 5 virtual disk, the spare disk needs to be online as quickly as possible. It is acceptable for users to experience decreased performance during the rebuild procedure.
How should this requirement met?

A.Increase Rebuild Rate
B.Enable Rebuild Priority
C.Change cache to Write Through
D.Select Fast Rebuild

Question 3

A technician needs to configure the Lifecycle Controller network settings with a static IP address. A limited number of static IP addresses are available for use.
Which previously assigned IP address can also be used for the Lifecycle Controller?

A.The default gateway IP address
B.The IP address of a different server on the network
C.The iDRAC IP address
D.The host operating system's IP address

Question 4

A technician needs to add a device to SupportAssist for Servers. Policy requires that NO additional software be installed on the server OS.
What information is required to add the device?

A.Username, Password, and IP address for OpenManage Server Administrator
B.Username, Password, and IP address for Dell TechDirect
C.Username, Password, and IP address or hostname for the iDRAC
D.Username, Password, and IP address or hostname for the server OS

Question 5

A technician needs to configure a server to PXE boot a server setup image with the BIOS in UEFI mode.
Which two steps should the technician perform to enable this function? (Choose two.)

A.From the iDRAC web interface, select Network Settings, and enable PXE Device1.
B.Navigate to Boot Options Settings and set PXE Device1 as first option.
C.Boot to Ctrl+S and configure the NIC for PXE Device1.
D.From System Setup Utility, choose Device Settings. Configure NIC for PXE.
E.Navigate to Network Settings, PXE Device1 Settings, and configure IP.