Free Dell DCPPE-200 Exam Dumps Questions & Answers

A customer has a VRTX with Shared PERC External cards cabled as shown in the exhibit. Which connection needs to be swapped to fix the cabling?

• A.EMM1_In with EMM1_Out
• B.EMM0_In with EMM1_In
• C.EMM0_In with EMM0_Out
• D.EMM0_Out with EMM1_Out

An engineer is deploying a new server node into an existing chassis for a virtualization cluster. The existing cluster nodes have many modified BIOS settings to meet workload needs.
How should the engineer quickly deploy the new server node with matching BIOS settings?

• A.Use System Setup to configure dynamic profile settings based on workload.
• B.Use the CMC Server Profiles to clone an existing server profile.
• C.Use the iDRAC GUI to replicate from an existing server profile.
• D.Use the Lifecycle Controller to mirror a cluster member profile.

An engineer enters a data center to configure an uplink between an I/O Aggregator (IOA) and an upstream switch. The IOA and upstream switch are configured for spanning tree. The engineer applies the following configuration to the uplink port:
interface TenGigabitEthernet 0/12
switchport
flowcontrol rx on tx off
spanning-tree rstp edge-port
As soon as the engineer plugs in the cables, it creates a loop and brings down the network.
Which commands should be entered on the IOA to fix loop?

• A.spanning-tree protocol rstpbridge priority 32768
• B.spanning-tree protocol rstpbridge priority 0
• C.interface TenGigabitEthernet 0/12no spanning-tree rstp edge-port
• D.interface TenGigabitEthernet 0/12spanning tree loop detect

What are three valid methods of capturing the configuration of a server node for re-deployment through CMC?

• A.Configuration Template exported from Open Manage Essentials. Server Configuration Profile exported from iDRAC using racadm. Server Profile exported to Extended Storage through the CMC.
• B.System Profile exported through the iDRAC Web interface. Configuration Template exported from Server Administrator. Server Configuration Profile exported from iDRAC using racadm.
• C.System Profile exported through the iDRAC Web interface. Configuration Template exported from Open Manage Essentials. Server Configuration Profile exported from iDRAC using racadm.
• D.Configuration Template exported from Server Administrator. Server Configuration Profile exported from iDRAC using racadm. Server Profile exported to Extended Storage through the CMC.

Refer to the exhibit.
An engineer receives a pair of the modules shown to install in a pair of MXL switches.
Which cables does the engineer need for this module?

• A.SFP+ to SFP+, 10GbE, Copper Twinax Direct Attach
• B.Cat6A Snagless Unshielded (UTP) Network Patch Cable
• C.OM4 MTP Crossover Fiber Cable (optics required)
• D.QSFP+ to QSFP+, 40GbE Passive Copper Direct Attach.