Free Dell DNDNS-200 Exam Dumps Questions & Answers

A networking engineer needs to configure several VLANs for S-Series switches for both Untagged and Tagged traffic.
Which three of the following apply? (Choose three.)

• A.When a Tagged interface is removed from a VLAN, it will always be placed in the default VLAN as a Tagged interface.
• B.Hybrid ports can be assigned to both an Untagged VLAN and Tagged VLAN.
• C.When a Tagged interface is removed from a VLAN, it will remain Tagged only if it is Tagged in another VLAN.
• D.Hybrid ports can be assigned to multiple VLANs but not the default VLAN.
• E.A Tagged interface can only be a member of a single Tagged VLAN.
• F.A Tagged interface can be a member of multiple VLANs.

A network engineer needs to remove switch 2 from a stack of four switches permanently.
Which process should the network engineer use?

• A.Option D
• B.Option C
• C.Option A
• D.Option B

Which of the following effectively describes basic iBGP?

• A.iBGP is a link-state protocol
• B.iBGP uses the AS path to prevent looping of routing information
• C.iBGP uses poison reverse to prevent looping of routing information
• D.iBGP requires a full mesh of peers to prevent looping of routing information

Refer to the exhibit.
On switch S4820-1, commands are entered. The associated output is as shown.

What correctly defines the state of the Root Bridge for VLAN 2 and VLAN 3?

• A.VLAN 2 Root Bridge - S4820-2VLAN 3 Root Bridge - S4820-1
• B.VLAN 2 Root Bridge - S4820-1VLAN 3 Root Bridge - S4820-2
• C.VLAN 2 Root Bridge - S4820-2VLAN 3 Root Bridge - S4820-2
• D.VLAN 2 Root Bridge - S4820-1VLAN 3 Root Bridge - S4820-1

The network engineer powers on a new S-Series switch. None of the devices connected to this new switch are responding to pings.
Which two conditions should the network engineer verify? (Choose two.)

• A.OSPF is enabled
• B.an ARP table is configured
• C.ports are not shut down
• D.the switch has a default Gateway
• E.ports are in switchport mode