Free EMC D-NWG-FN-23 Exam Dumps Questions & Answers

The network administrator wants to configure RADIUS authentication for VTY access, and for console access to use the local configuration. Which two commands should be used to achieve this goal?

• A.aaa authentication login vty radius
  aaa authentication login console group local
• B.aaa authentication login default group radius aaa authentication login console local
• C.aaa authentication login vty group radius aaa authentication login console local
• D.aaa authentication login default group radius aaa authentication login console group local

A customer has disabled LLDP on the management interface of the switch. What is the proper command to re- enable it?

• A.OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp tly-select OS10(conf-if-ma-1/1/1)#lldp dot1tlv
• B.OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp transmit OS10(conf-if-ma-1/1/1)#lldp receive
• C.OS10(config)# lldp enable OS10(config)#lldp transmit OS10(config)#lldp receive
• D.OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp med enable OS10(conf-if-ma-1/1/1)#lldp timer 10

What is the valid range of VLAN IDs for Dell EMC Networking OS10 switches?

• A.0-4092
• B.0-4095
• C.1-4096
• D.1-4093

A customer reports they can no longer access their services and a network administrator has been assigned to investigate. A UFD disabled error status appears on all ports. What caused the issue?

• A.Both a port channel and its members were assigned to an uplink-state group.
• B.Spanning tree Loop-guard was implemented on the uplink-state group.
• C.One of the upstream interfaces is an uplink-state group went down.
• D.There was no issue; this is normal behavior.

In a PIM Sparse Mode (PIM-SM) based multicast topology, what function does the Rendezvous Point provide?

• A.The node is used to provide IGMP snooping across a layer 3 boundary.
• B.The node is used to provide IGMP snooping on a layer 2 shared segment.
• C.The root node of the source tree topology is used to provide routing between the source and receiver.
• D.The root node of the shared tree topology is used to provide routing between the source and receiver.