Free EMC DEE-1721 Exam Dumps Questions & Answers

A storage administrator has an 8 TB database. Half of the data is hot and frequently accessed. The other half of the data is older with infrequently used cold dat a. The administrator purchased 12, 800 GB SLC SSDs and placed them in a new disk folder called
"Database".
The administrator then created volumes for this database in the Database disk folder using the recommended storage profile. After the database had been running for one month, the Statistics tab for the database volumes showed 100% of the space is on Tier 1. However, the administrator expected that half of the data would be on Tier 1 and the rest would be moved to lower tiers.
What are the reasons for this issue?

• A.Data Progression does not run on database volumes
  Database vendors have specific requirements for laying out their data across tiers
• B.Volumes were created in the Database disk folder
  Data Progression cannot move the cold data to the lower tier disks
• C.Sufficient space is available on Tier 1 for the entire 8 TB database Event cold data will remain on Tier 1 until it becomes full
• D.Recommended storage profile will only use SSD tiers if any are available Cold data cannot move to the lower tier disks

Refer to the Exhibit:

If a user expires Replay 2, which page(s) is deleted?

• A.A1 and C1
• B.A1 only
• C.B, D, and E
• D.C1 only

You need to physically install an I/O card into an SC9000 storage array. What must be considered when installing the I/O card?

• A.I/O card BIOS and IPC connection
• B.I/O slot priority and I/O card BIOS
• C.ESD and I/O slot priority
• D.IPC connection and ESD

You are performing failover testing on an FC-attached dual controller SC8000 storage array. You notice that the storage administrator's Microsoft Windows 2008 R2 servers experience I/O errors. However, the RHEL and ESX servers are not experiencing any problems. All FC HBA time outs are configured based on Dell EMC best practices.
In addition, the Windows servers that are experiencing issues have had no OS-level configuration changes related to SAN storage. All servers use the same FC fabric. What is causing the connectivity loss during failover?

• A.FC cables plugged into the Windows servers have RX and TX reversed
• B.Incorrect OS type was selected when the Windows server objects were created
• C.NPIV is not enabled on the Storage Center FC local ports
• D.Windows disk timeout value is set incorrectly

A storage administrator has multiple servers connected to the Storage Center through two iSCSI networks.
You use a software iSCSI Initiator on the servers and the Storage Center runs in Virtual Port Mode.
Which IP address is required in the iSCSI Initiator for proper connectivity?

• A.Primary IP address for each domain
• B.Reserve IP address for each domain
• C.Management IP address of each controller
• D.Control Port IP address for each domain