An engineer needs to install an additional PSU on an existing, single PSU Dell EMC PowerEdge R740. They complete the initial installation and cabling procedures. They connect an AC cable and the power distribution unit produces normal AC output. The engineer checks power management and sees that the new PSU is in the Failed state.
What task should be completed to troubleshoot this issue?

• A.Verify the new PSU is the same type and wattage rating
• B.Set the PSU AC redundancy to 1+1
• C.Confirm the System Input Power CAP is not set to Low
• D.Set the PSU AC redundancy to 1+0

Comment: *

Name: *

Email: *

Verification: *

Where is the data stored to allow Easy Restore to successfully complete a system board replacement?

• A.IDSDM SD card
• B.NAND Flash module on the disk drive mid plane
• C.Serial Flash storage in the server's front panel
• D.vFlash SD card

Comment: *

Name: *

Email: *

Verification: *

You are Investigating a disk error on a Dell EMC PowerEdge server and discover a Hot Spare has not been assigned to the Virtual Disk Group. Use the simulator to assign the Global Hot Spare. When you have finished using the simulator, dick Next.

Comment: *

Name: *

Email: *

Verification: *

Which type of access is known as Firmware RACADM on a Dell EMC PowerEdge server?

• A.Logging into iDRAC using SSH or Telnet
• B.Accessing RACADM running the Dell Toolkit
• C.Accessing RACADM with OpenManage software
• D.Logging into iDRAC through Boot Manager

Comment: *

Name: *

Email: *

Verification: *

A Dell EMC PowerEdge 14G server uses Intel OPTANE DC Persistent Memory in App Direct mode. What is the minimum size DIMM supported for this type of memory?

• A.128 GB
• B.256 GB
• C.512 GB
• D.64 GB

Comment: *

Name: *

Email: *

Verification: *