What version of IGMP is required by PIM-SSM receivers?

• A.IGMP 1
• B.IGMP snooping
• C.IGMP 3
• D.IGMP 2

Comment: *

Name: *

Email: *

Verification: *

When the show ip bgp neighbors command is issued, which BGP state reflects a successfully created adjacency with another BGP peer?

• A.ACTIVE
• B.ESTABLISHED
• C.PEERING
• D.CONNECTED

Comment: *

Name: *

Email: *

Verification: *

You have been asked to examine a BGP configuration for a co-worker who is having difficulty establishing BGP peering. The address shown is that of the neighbor's Lo0 interface. Given the configuration shown, what would be your recommendation?
S3(config-router-bgp-65042)# neighbor 192.168.32.1
S3(config-router-neighbor)# remote-as 65042

• A.Modify the existing configuration to be:
  S3(config-router-bgp-65042)# neighbor 192.168.32.1/24
  S3(config-router-neighbor)# peer-as 65042
• B.Add the following to the existing configuration:
  S3(config-router-neighbor)# update-source loopback 0
  S3(config-router-neighbor)# no shutdown
• C.Issue the no shutdown command and verify that the BGP state is ESTABLISHED
• D.Issue the no shutdown command and verify that the BGP state is ACTIVE

Comment: *

Name: *

Email: *

Verification: *

Which command is used to create a non-default VRF instance?

• A.ip vrf forwarding vrf-test
• B.ip vrf
• C.interface ethernet 1/1/1
• D.ip vrf forwarding new-vrf

Comment: *

Name: *

Email: *

Verification: *

There is a spanning tree mismatch at the global level. PVST+ is configured on a VLT peer. All VLT port channels go down on both VLT peers. A syslog error message is generated. What is the correct action to resolve the issue?

• A.Verify the VLT LAG ID is configured correctly on both VLT peers.
• B.Enable RSTP on both VLT peers.
• C.Use the show VLT detail and show VLT brief commands to view the VLT port channel status information.
• D.Perform a mismatch check after the VLT peer is established.

Comment: *

Name: *

Email: *

Verification: *