Free EMC E22-285 Exam Dumps Questions & Answers


Exam Code/Number:	E22-285Join the discussion
Exam Name:	VxRail Appliance 4.x Deployment and Implementation Exam
Certification:	EMC
Free Question Number:	80
Publish Date:	Jan 03, 2026
# of views:	3063
Rating 100%

Page: 1 / 16
Total 80 questions

Question 1

During a VxRail installation, the deployment fails at 9%. Based on the exhibit, what could be the reason for this failure?

A.vCenter and PSC information is missing
B.Timezone is in an incorrect format
C.Domain name .local is not supported
D.Password field has an extra space

Question 2

What accurately describes VxRail G Series nodes?

A.All nodes in a chassis must be identical.
B.Hybrid and all-flash nodes are permitted if in different chassis.
C.Different dot releases of the same major release are permitted if in different chassis.
D.Each chassis must be fully populated.

Question 3

When validating the VxRail health just after the VxRail initial configuration, there is a red exclamation mark on the MARVIN-Virtual-SAN-Cluster and the reported health alarm is
'Component metadata health'. A "Retest" action in the health service panel is performed and all the nodes in the cluster show health status as failed with the invalid state.
Investigation does not reveal any hardware issues with the disks in use by vSAN.
What action should be taken next?

A.Reapply the MARVIN storage policy to the VxRail internal virtual machines
B.Evacuate and destroy the disk/disk group that contains the component(s) reporting errors and clear the alarm
C.Wait 24 hours, then click the "Retest" button again
D.Apply the vSphere ESXi600-201611001 patch, then click the "Retest" button again

Question 4

When using the RASR method to reset a VxRail node, which boot device is selected?

A.IDRAC SD CARD
B.IDSDM
C.SATADOM
D.RASRUSB

Question 5

During the deployment of VxRail, you import a JSON file and attempt a validation. An error indicates that node 1 cannot access the other nodes. When you look at the Nexus switchport configuration, you see the following on all VxRail ports:
interface TenGigabitEthernet 1/x
switchport
switchport trunk
switchport trunk allow vlan all
What is a possible reason for this situation?

A."switchport trunk native vlan x" is notconfigured
B."switchport access vlan x" is not configured
C."switchport vlan x" is not configured
D."switchport trunk vlan x" is not configured