Assume a client's traffic is being processed only by a NAT; no SNAT or virtual server processing takes place. Also assume that the NAT definition specifies a NAT address and an origin address while all other settings are left at their defaults. If a client were to initiate traffic to the NAT address, what changes, if any, would take place when the BIG-IP processes such packets?

• A.The destination address would not change, but the source address would be translated to the origin address.
• B.The source address would not change, but the destination address would be translated to the NAT's address.
• C.The source address would not change, but the destination address would be translated to the origin address.
• D.The destination address would not change, but the source address would be translated to the NAT's address.

Comment: *

Name: *

Email: *

Verification: *

Which IP address will the client address be changed to when SNAT automap is specified within a Virtual Server configuration.

• A.It will alternate between the floating and noEl nfloating self IP address on the VLAN where the packet leaves the system so that port exhaustion is avoided.
• B.The floating self IP address on the VLAN where the packet arrives on the system.
• C.It will alternate between the floating and noElfnloating self IP address on the VLAN where the packet arrives on the system so that port exhaustion is avoided.
• D.The floating self IP address on the VLAN where the packet leaves the system.

Comment: *

Name: *

Email: *

Verification: *

Interface 1.2 on a BIG-IP VE has a status of UNINITIALIZED. What is the reason for this status?

• A.Interface 1.2 has been added to a trunk.
• B.Interface 1.2 has NOT been assigned to a VLAN.
• C.Interface 1.2 has been disabled.
• D.No default route has been created.

Comment: *

Name: *

Email: *

Verification: *

Which two can be a part of a virtual server's definition? (Choose two.)

• A.monitor(s)
• B.pool(s)
• C.rule(s)
• D.loadbalancing method(s)
• E.node address(es)

Comment: *

Name: *

Email: *

Verification: *

Which two statements are true about SNATs? (Choose two.)

• A.SNATs can be configured within a Profile definition.
• B.SNATs are enabled on all VLANs, by default.
• C.SNAT's are enabled only on the VLAN where origin traffic arrives, by default.
• D.SNATs can be configured within a Virtual Server definition.

Comment: *

Name: *

Email: *

Verification: *