An LTM Specialist has trouble with SNMP traps in the management network The ITM Specialist takes the network capture shown to troubleshoot:

What should the UM Specialist change to capture packets related to this workflow?

• A.the tcpdump filter expression
• B.the interface
• C.the verbose level
• D.the port

Comment: *

Name: *

Email: *

Verification: *

An LTM Specialist to configure a backend server to be disabled it takes longer than 30 seconds to respond to a request.
Which values should the LTM Specialist enter for interval and timeout?

• A.Interval 30, timeout 91
  The official recommendation is that timeout 3 times the interval value +1.
• B.Interval 10, timeout 31
• C.Interval 10, timeout 30
• D.Interval 30, timeout 30

Comment: *

Name: *

Email: *

Verification: *

An LTM Specialist is the administrator of an HA pair that contains two BIG IP units and one floating traffic group (TG1). A new project requires the creation of 30 virtual servers. The Specialist decides to create a new floating traffic group (TG2) to handle this requirement. Objects for this project created by the BIG-IP Managers must appears in the correct traffic group.
Which configuration should the LTM Specialist use to meet the requirement?

• A.Move the BIG-IP Managers from TG1 to TG2
• B.Create a new partition and set the default traffic group to TG2
• C.Restrict the Traffic Group Access of BIG-I Managers to TG2
• D.Modify the default traffic group of the Common partition to TG2

Comment: *

Name: *

Email: *

Verification: *

Refer to the following iRule:

What is a complete list of profiles that must be applied to the virtual server for this iRule?

• A.Fast L4 , HTTP, Stream
• B.Fast L4, HTTP
• C.TCP, HTTP
• D.TCP, HTTP, Client SSL

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

The LTM devices LTM3 and LTM2 have four Traffic Groups defined with approximately the sar of failover objects defined in each group.
- Traffic Groups A and C have Default Device set to LTM1
- Traffic Groups Band D have Default Device set to LTM2.
- Traffic Groups B and C do NOT have Auto Failback enabled. Traffic Groups A and D have Auto Failback enabled with a timeout value of 60 seconds.
- Traffic Groups A and D have Auto Fallback enabled with a timeout value of 60 seconds.
Both LTM devices are healthy and able to pass traffic for any Traffic Group.
LTM1 loses connectivity on interface 1.4. The LTM Specialists notified 60 seconds after the interface goes down.
What is the state of the Traffic Groups on each LTM device?

• A.LTM1: Traffic Group C
  LTM2: Traffic Groups A, B, and 0
• B.LTM1: No Traffic Groups
  LTM2: Traffic Groups A, B, C, and D
• C.LTM1: Traffic Groups A, B, C, and D
  LTM2: No Traffic Groups
• D.LTM1: Traffic Groups B and C
  LTM2: Traffic Groups A and 0

Comment: *

Name: *

Email: *

Verification: *