You are creating the CLI script to be used on a new SD-WAN deployment. You will have branches with a different number of internet connections and want to be sure there is no need to change the Performance SLA configuration in case more connections are added to the branch.
The current configuration is:

Which configuration do you use for the Performance SLA members?

• A.set members any
• B.set members 0
• C.current configuration already fulfills the requirement
• D.set members all

Comment: *

Name: *

Email: *

Verification: *

You are hosting Web applications that must be PCI DSS compliant. The Web applications are protected by a FortiWeb. Compliance will be tested during the quarterly security review. In this scenario, which three FortiWeb features should you use? (Choose three.)

• A.Credit Card Detection
• B.Auto-learning
• C.the config system advanced set weark_enc disable end command.
• D.Vulnerability Scan
• E.Syn Cookie

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Central NAT was configured on a FortiGate firewall. A sniffer shows ICMP packets out to a host on the Internet egresses with the port1 IP address instead of the virtual IP (VIP) that was configured Referring to the exhibit, which configuration change will ensure that ICMP traffic is also translated?

• A.
• B.
• C.
• D.

Comment: *

Name: *

Email: *

Verification: *

FortiMail is configured with the protected domain "internal.lab".
Which two envelope addresses will need an access control rule to relay e-mail sent for unauthenticated users? (Choose two.)

• A.MAIL FROM: [email protected]; RCPT TO: [email protected]
• B.MAIL FROM: [email protected]; RCPT TO: [email protected]
• C.MAIL FROM: [email protected]; RCPT TO: [email protected]
• D.MAIL FROM: [email protected]; RCPT TO: [email protected]

Comment: *

Name: *

Email: *

Verification: *

Which three statements about throughput on a wireless network are true? (Choose three.)

• A.A wireless device labelled as 300 Mbps should be expected to provide a throughput of 300Mbps.
• B.Be careful to ensure the capabilities of the wireless clients match those of the access points, in order to achieve higher throughput.
• C.Reducing the duty cycles of the wireless media by generating fewer beacons may improve throughput.
• D.Because of the higher level of RF noise that is typical in the 2.4 GHz ISM band, throughput of 2.4 GHz devices will typically be less than 5 GHz devices.
• E.Because of the full-duplex nature of the medium and the minimal overhead generated by CSMA/CA, the actual aggregate throughput is typically close to the data rate.

Comment: *

Name: *

Email: *

Verification: *