Free H3C GB0-342-ENU Exam Dumps Questions & Answers

The following APs that belong to the Terminator split pass-through mode are:

• A.WTU420H
• B.WTU430H
• C.WTU430H-IOT
• D.WTU430

Contents and concerns of survey decision-making include ?

• A.Approve the total number of APs required for coverage, and add a 5%~10% margin
• B.Calculate the number of access switch ports connected to the AP, and make the number ratio according to the actual situation. At the same time, it needs to be considered in combination with the power supply mode (when using POE/POE+ mode, the output power of the switch).
• C.Determine the AP selection mode (11agn, 11ac, single and dual frequency) and the exact installation position
• D.Determine the antenna type corresponding to the AP (built-in antenna, ceiling antenna, outdoor antenna, etc.)

The correct way of waterproofing the feeder interface is

• A.First wrap it with insulating tape, then wrap it with a layer of insulating tape, and finally add a layer of waterproof tape to seal.
• B.First wrap it with waterproof tape, then wrap it with a layer of insulating tape, and finally add another layer of insulating tape to seal.
• C.First wrap it with insulating tape, then wrap it with a layer of waterproof tape, and finally add another layer of insulating tape to seal.
• D.First wrap with waterproof tape, then wrap with a layer of insulating tape, and finally add another layer of waterproof tape to seal.

The maximum transmit power of indoor WLAN devices should generally not exceed

• A.50mW
• B.100mW
• C.500mW
• D.1000mW

The term describing the combined effect of transmit power and antenna gain is ( )

• A.dBm
• B.dBi
• C.path-loss
• D.EIRP