Free HP HP0-Y43 Exam Dumps Questions & Answers

Which security protocol introduces vulnerabilities because the password is sent in plaintext and can be intercepted and easily read?

• A.EAP
• B.PAP
• C.WEP
• D.CHAP

Which statement accurately describes how network administrators can apply routed access control lists (RACLs) or VU\N access control lists (VACLs) on an HP 8200 zl switch?

• A.A VACL applies to traffic routed within a particular VLAN.
• B.A VACL applies to any traffic switched within a VLAN.
• C.A RACL controls all inbound or outbound routed traffic on a particular port.
• D.A RACL is applied at the global configuration level to filter all traffic routed on the switch.

View the exhibit.

Several HP Provision ASIC switches are implementing PIM. Based on the configurations shown in the exhibit, which switch is included in the dynamic RP set?

• A.routing switch B
• B.routing switch A
• C.routing switch C
• D.routing switch D

What is the role of neighbor solicitation (NS) messages in the autoconfiguration of an IPv6 address?

• A.An IPv6 node sends an NS message for its tentative address to determine whether another node is using it.
• B.An IPv6 node sends an NS message for the global prefix to prompt other IPv6 nodes to advertise the addresses that they are using on that prefix.
• C.An IPv6 node sends an NS message to inform a node undergoing autoconfiguration that it is already using a particular address.
• D.An IPv6 node sends an NS message to prompt an IPv6 router on the link to advertise the global prefixes associated with the link immediately.

A network administrator enables OSPF on an HP Provision ASIC switch and creates area 0 and area 1.
The network administrator then enters this command:
Switch(ospf)# area 1 range 10.1.0.0/16
After other switches are configured and establish adjacencies, how will this command affect the final
behavior of the switch?

• A.The switch will become an area border router (ABR) capable of advertising summary LSAs.
• B.The switch will send advertisements for networks within the 10.1.0.0/16 range into the backbone area.
• C.The switch will send a single summary LSA into the backbone area for all networks in the 10.1.0.0/16 range.
• D.The switch will send and accept OSPF messages on VLAN interfaces with the 10.1.0.0/16 range.