Free HP HP0-Y47 Exam Dumps Questions & Answers

Refer to the exhibit.

Router 4, which is an HP Comware router, redistributes Routing Information Protocol (RIP) routes into Open Shortest Path First (OSPF) process 1. Router 4 has several dozen IP routes, and the network administrator wants to minimize the number of external routes throughout the entire OSPF AS. How can the administrator meet this requirement?

• A.On all OSPF devices in area 0, set area 0 as a not-so-stubby-area (NSSA)
• B.On all OSPF devices, configure all OSPF areas, including area 0, as stub areas.
• C.Create an ASBR summary for the RIP routes on Router 4.
• D.Create an ABR summary for the RIP routes on Router 2 and Router 3.

Refer to the exhibit.

Which route to 203.0.13.0/24 will the switch BGP process propose to the routing table?

• A.A route through 192.0.2.2
• B.A route through 198.5.100.1 and 192.0.2.1
• C.A null route
• D.A route through 198.5.100.1

HOTSPOT
Match each characteristic to the connect multicast routing protocol. If both protocols exhibit characteristic, you must select both.

Correct Answer:

Refer to the exhibit.

These three routers are currently configured for BGP. They do not apply any routing policy in terms of BGP on routes or attributes advertised to an received from peers. How can the network administrator for Router 1 cause Router 1 to advertise 192.0.2.0/24 to Router 2
and Router 3?

• A.Apply route policy 1 as an outbound policy for both peers
• B.Apply route policy 1 as an inbound policy for both peers
• C.Enable BGP routing on RAGG1
• D.Add a null route to 192.0.2.0/24

Refer to the exhibit.

A server connects to GigabitEthernet1/0/1 on an HP Comware switch. The server sends tagged traffic in VLAN2. It has an application that sets the DiffServ Code Point (DSCP) for its traffic to 16 and the 802.1p value to 2. The switch should use the DSCP to place the traffic in priority queue.The traffic belongs to the queue that is one priority level higher than the queue for best effort traffic(traffic without a QoS value)
What can the network administrator do to meet this requirement?

• A.Change the dot1p-lp map to map 802.1p value 2 to lp 2 and 802.1p value0to lp1.
• B.Change the dscp-dot1p map to map DSCP 16 to 802.1p value 1.RECEIBE priority 0
• C.Keep Gigabit Ethernet1/0/1's QoS trust setting to "dot1p" Set the port priority to 3.
• D.Change GigabitEthernet1/0/1's trust setting to "dot1p" set the port priority to 3.DSCP will not be used