Free HP HP2-Z34 Exam Dumps Questions & Answers

An administrator binds VLAN interface 10 to VPN instance "TenantA" on an HP Comware
switch by using this configuration:
interfaceVlan-interface 10
ip address 10.1.10.1 255.255.255.0
How does the administrator's action affect the interface IP address?

• A.The IP address remains 10.1.10.1/24 but is extended with the Route Distinguisher (RD) and can now be assigned to an interface in another VPN instance.
• B.The interface loses the IP address, and the administrator must configure the IP address on this interface again.
• C.The IP address remains 10.1 10.1/24. but now this subnet can also be assigned to an interface in another VPN instance.
• D.The interface loses the IP address and the administrator must map the interface to 10.1 10.1/24 from the VPN instance context

An HP IRF virtual switch with two members is implementing TRILL. The administrator wants to ensure that the master can fail without causing topology changes or changes in forwarding tables in the TRILL region. Which setting helps support this requirement?

• A.Bidirectional Forwarding Detection (BFD) Multi-Active Detection (MAD) for the IRF link
• B.calculation of at least two trees
• C.non-stop-forwarding for TRILL
• D.Graceful Restart for TRILL

Refer to the exhibit

An administrator is creating the EVI network shown in the exhibit Switches 1 and 2 are configured as ENDP servers. and Switch 3 is configured as an ENDP client to the ENDP servers. Which configuration is correct for the EVI tunnel interface on Switch 3?

• A.The source IP address is the switch router ID; no other destination IP addresses need to be set.
• B.The source IP address is the switch router ID; the addresses for switches 1. 2. and 4 need to be set as destinations
• C.The source IP address is the address on the connection to the service provider; the addresses for switches 1, 2, and 4 need to be set as destinations
• D.The source IP address is the address on the connection to the service provider; no other destination IP addresses need to be set.

An HP Comware Switch 1 supports FCoE for connected servers with Converged Network Adapters (CNAs). On interface Ten 1/0/1 Switch 1 sends FCoE traffic in VSAN 2 to an upstream switch. Switch 2which also supports FCoE What is the correct configuration for interface Ten 1/071?

• A.FC access port in VSAN 2
• B.bound to a VFC interface, which is an access port in VSAN 2
• C.bound to a VFC interface, which is a trunk port and permits VSAN 2
• D.FC trunk port, which permits VSAN 2

Refer to the exhibit

An administrator is setting up MPLS Layer 2 VPN connections between several customer sites and wants to send traffic that arrives on G1/0/1 with VLAN tag 102 to Site 2. Traffic with a different tag will be sent to adifferent site.How should the administrator implement this'?

• A.Set the encapsulation for service-instance 1 to S-VLAN 102
• B.Set the peer PW outer label to 102 in xconnect-group Site1toSite2.
• C.Remove service-instance1 from interface G1/0/1 and add it to VLAN 102
• D.Set the peer PW inner label to 102 in xconnect-group Site1toSite2.