Refer to the exhibit.

Which statement about this logical interconnect group is true?

• A.Both master modules are located in the same HPE S ynergy frame
• B.To use interconnect bay set 3, all compute nodes must be half-height
• C.The master modules are located in the interconnect bays 2 and 5
• D.For the given downlink speed, the maximum number of frames is reached

Comment: *

Name: *

Email: *

Verification: *

Your customer has a logical enclosure configured using a angle HPE Synergy frame with the following configuration
- two HPE Virtual Connect SE 100Gb F32 Modules for Synergy
- two HPE Synergy Virtual Connect SE 32Gb FC Modules -12 HPE Synergy 480 Gen10 Plus compute nodes with appropriate mezzanine cards They plan to add a new HPE Synergy frame to an existing logical enclosure with the following configuration
- two HPE Synergy Virtual Connect SE 32Gb FC Modules
- two HPE Synergy 20Gb interconnect Link Modules
- Eight HPE Synergy 480 Gen 10 Plus compute nodes with appropriate mezzanine cards Which statement about the planned configuration change is true?

• A.The two HPE Synergy 20Gb interconnect Link Modules must be replace with the 50Gb option
• B.The HPE Synergy virtual Connect SE 32Gb FC Modules from both frames should be stacked
• C.A license for an extended logical enclosure must be added to HPE OneView through GUI
• D.Four compute modules must be moved to the second frame to balance the configuration

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

Which statement about this logical interconnect group is true?

• A.Both master modules are located in the same HPE S ynergy frame
• B.For the given downlink speed, the maximum number of frames is reached
• C.To use interconnect bay set 3, all compute nodes must be half-height
• D.The master modules are located in the interconnect bays 2 and 5

Comment: *

Name: *

Email: *

Verification: *

Your customer is implementing an HPE Synergy solution based on three frames.
Click each of the ports that can be used to connect satellite modules.

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

You need to configure a RoCE network to enable lossless networking for HPE J2000 Flash Enclosure support Which interconnects are required to support this connection? (Select two.)

• A.HPE Virtual Connect SE 32Gb FC Module for HPE Synergy
• B.HPE Virtual Connect SE 16Gb FC Module for HPE Synergy
• C.HPE Virtual Connect SE 40Gb F8 Module for HPE Synergy
• D.HPE Virtual Connect SE 100Gb F32 Module for HPE Synergy
• E.Brocade 32Gb Fibre Channel SAN Switch Module for HPE Synergy
• F.Brocade 16Gb Fibfe Channel SAN Switch Module for HPE Synergy

Comment: *

Name: *

Email: *

Verification: *