A customer needs to verify inbound packet statistics for interface. Ten-GigabitEthernet 1/0/10 on an HPE FlexFabric 5900 series switch used by an iSCSI storage array.
Which command can be used in the CLI to perform this operation?

• A.show inbound counters port 1/0/10
• B.display all statistics from port 1/0/10
• C.interface Ten-GigabitEthernet 1/0/10 show counters
• D.display counters inbound interface Ten-GigabitEthernet 1/0/10

Comment: *

Name: *

Email: *

Verification: *

Match each ProLiant solution to its ideal use case

Correct Answer:

Comment: *

Name: *

Email: *

Verification: *

You are reviewing a series of MSA2052 storage designs for a customer's remote locations. Their largest
remote site requires the highest possible level of internal data protection with at least 20 TB of storage. Which disk drive design is adequate for this site?

• A.10 HPE MSA 2 TB drives, configured with RAID0
• B.14 HPE MSA 2 TB drives, configured with RAID1
• C.8 HPE MSA 2 TB drives, configured with RAID5
• D.12 HPE MSA 2 TB drives, configured with RAID6

Comment: *

Name: *

Email: *

Verification: *

A company plans to purchase new HPE servers. The company needs to maximize local storage capacity within the servers.
Which HPE servers should the company install?

• A.ProLiant DL360 Gen 9
• B.ProLiant DL380 Gen10
• C.ProLiant ML110 Gen 9
• D.ProLiant BL460c Gen10

Comment: *

Name: *

Email: *

Verification: *

A customer requests a quote for an HPE storage solution that meets these requirements
* fully redundant dual-controller storage array with no single points of failure
* 1 Gb or 10 Gb ISCSI connectivity
* at least four host-facing ISCSI ports
* capable of expanding usable capacity in small increments of one-to-two disks
Which HPE storage solution should be proposed?

• A.Nimble HF20
• B.Nimble AF20Q
• C.D3000
• D.MSA 1050

Comment: *

Name: *

Email: *

Verification: *