Free HP HPE6-A46 Exam Dumps Questions & Answers

A company requires AOS-Switches at the campus core. The switches:
* Will act as the default gateways for several campus VLANs
* Must provide redundancy for their services and tolerate the loss of a link or an entire switch
* Must recover from the failure of one of the switches within a second or less VRRP and MSTP are proposed to meet these requirements. What is an issue with this proposal?

• A.VRRP provides routing redundancy but not default gateway redundancy.
• B.VRRP provides redundancy against lost links but not a failed switch.
• C.VRRP does not interoperate with MSTP.
• D.VRRP takes longer than a second to fail over.

Refer to the exhibits.
Exhibit 1

Exhibit 2

The network administrator needs to set up BGP between the two company switches, Switch-1 and Switch-2.
The BGP connection does not establish. Based on the exhibits, what does the administrator need to do to fix the issue?

• A.Set the update source for the neighbor to the local loopback interface on each switch.
• B.Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.
• C.Enable BGP on the interfaces that the switches use to reach each other.
• D.Enable the multihop option for the neighbor on each of the switches.

Refer to the exhibits.

Exhibit 2

The network administrator configures the commands shown in Exhibit 2. Which mismatch will cause an issue?

• A.the mismatch between the key-strings in the chains for VLAN 10 and VLAN 11 on Switch-1
• B.the mismatch between the key IDs specified in chain10 and chain11 on Switch-1
• C.the mismatch between the key-strings associated with VLAN 10 on Switch-1 and on Switch-2
• D.the mismatch between the chain names associated with VLAN 11 on Switch-1 and on Switch-3

Which switches can be deployed in a mesh topology for backplane stacking?

• A.Aruba 2930M switches
• B.Aruba 2920 switches
• C.Aruba 2930F switches
• D.Aruba 3810 switches

Refer to the exhibit.

Switch-2, Switch-5, and Switch-6 currently have many OSPF routes to Area 1 networks. The network administrator wants to replace these routes with a single aggregated route to 10.1.0.0/16 on each switch.
Where should the administrator specify the 10.1.0.0/16 range?

• A.in the Switch-2 OSPF Area 2 configuration
• B.in the Switch-2, Switch-5, and Switch-6 OSPF global configuration
• C.in the Switch-1 OSPF Area 1 configuration
• D.in the Switch-1 OSPF Area 0 configuration