An administrator defines credentials in the Mobility Master> Configuration> System section to configure a Mobility Master (MM). The administrator then accesses AirWave and adds the MM in Monitor-Only mode.
The administrator expects AirWave to automatically discover the Aruba Virtual Mobility Controllers (VMCs) also managed by the MM, but does not see these under APs/Devices> New section in AirWave.
What should the administrator do to solve this problem?

• A.Define the AirWave communication parameters on the Virtual Mobility Controllers, and then scan for the Virtual Mobility Controllers in AirWave.
• B.Enable Automatic Device Authorization for the Group the Mobility Master belongs to in AirWave.
• C.Define AirWave communication parameters for the Virtual Mobility Controllers on the Mobility Master, and have AirWave repoll the Mobility Master.
• D.Define AirWave communication parameters for the Virtual Mobility Controllers on the MobilityMaster, and then scan for the Virtual Mobility Controllers in AirWave.

Comment: *

Name: *

Email: *

Verification: *

Anadministrator currently manages an L2 cluster with Aruba Mobility Controllers (MCs) that run ArubaOS
8.x. What happens when the administrator enables AP load balancing?

• A.AP load balancing occurs when the rebalance and unbalance thresholds are met.
• B.AP load balancing is triggered based on the amount of user traffic thatusers generate.
• C.Users must re-authenticate if they are moved from one controller to another because load balancing is performed.
• D.Balancing of users is based on a hash of their IP address.

Comment: *

Name: *

Email: *

Verification: *

An administrator wants to add a new folder in AirWave. Where would the administrator perform this action?

• A.in AP/Devices
• B.in Groups
• C.in AMP Setup
• D.in Device Setup

Comment: *

Name: *

Email: *

Verification: *

Refer to the exhibit.

An administrator examines the configuration of an AP from apboot mode shown in the exhibit.
What can the administrator determine from the configuration?

• A.RAP terminated on a stand-alone controller.
• B.RAP terminated on a Mobility Master.
• C.AP terminated on a non-cluster Mobility Controller.
• D.AP terminated on a Mobility Controller in a cluster.

Comment: *

Name: *

Email: *

Verification: *

An administrator wants to simulate network traffic and analyze results in an Aruba wireless network to test components such as WPA-2, DHCP, and other protocols. Which Aruba solution implements thesefunctions?

• A.AirWave VisualRF
• B.AirWave RAPIDS
• C.Clarity Synthetic
• D.Clarity Live

Comment: *

Name: *

Email: *

Verification: *