Free HP HPE7-A08 Exam Dumps Questions & Answers

Refer to the exhibit:

The interface is configured on an HPE Aruba Networking CX 8320 for a VMware server NIC, and the server admin reports that VMware vMotion traffic on VLAN 3903 fails, but the server can ping other ports with default settings.
What must be done to correct the issue based on the provided interface status and configuration?

• A.Configure MTU 9198 on interface 1/1/36
• B.Configure jumbo on VLAN 3903
• C.Configure jumbo on interface 1/1/36
• D.Configure MTU 9198 on VLAN 3903

An eBGP configuration is set up from HPE Aruba Networking CX 6300 to two peers. Both peers advertise the 10.200.0.0/23 subnet with the default configuration. What configuration implementation would prefer this route using peer A over B?

• A.Define a route-map with set metric 200 and bind it to peer A BGP import configuration.
• B.Define a route-map with set local-preference 200 and bind it to peer A BGP import configuration.
• C.Define a route-map with set metric 200 and bind it to peer B BGP import configuration.
• D.Define a route-map with set local-preference 200 and bind it to peer B BGP import configuration.

Refer to the exhibit:

The primary VSX switch has a DHCP relay configured; however, the secondary switch does not display the DHCP relay configuration in the running configuration.
How can the VSX configuration be changed to have the same config on both nodes?

• A.On the primary switch, add vsx-sync dhcp-relay under VSX configuration.
• B.On the secondary switch, add vsx-sync ip-helper under VSX configuration.
• C.On the primary switch, add vsx-sync ip-helper under VSX configuration.
• D.On the secondary switch, add vsx-sync dhcp-relay under VSX configuration.

You are reviewing the configuration of a VSX lag and have noticed the command lacp fallback. Why might this have been configured?

• A.For operation using a single partner LACP interface.
• B.For backwards compatibility with LACP v1.
• C.To support devices that require PXE Boot.
• D.To allow operation with active or passive LACP.

A recent routing change has caused an outage to one of your customer's branch sites. You are about to run the command below:
copy checkpoint 20240722 running-config
Which troubleshooting methodology does this exemplify?

• A.Replace configuration
• B.Spot the difference
• C.Divide and conquer
• D.Top-down/Bottom-up